User's Manual

ManualsBrandsIone International ManualsComputers & Accessories2.4GHz Wireless Joystick Keyboard

ENGLISH

Scorpius-P20

2.4GHz Wireless Joystick Keyboard

User Guide

Introduction

Thank you for purchasing Scorpius-P20 2.4GHz Wireless Joystick Keyboard.

For an ideal performance, please follow the instructions of this user guide. If you

have any question, please contact us at www.ione.com.tw or www.itron-europe.com

Scorpius-P20 combines mouse and keyboard functions in one device with

advanced technology to work with your media center system. This is a plug and

play device under Win ME/2000/XP.

Features

• Built-in 360 ﾟ joystick and buttons for mouse function

• 2.4GHz RF with 8 channels / 8 ID per channel

• Up 10 meter operation range

• Low power consumption

• Compatible with Microsoft WIN 95/98/ME/2000/XP

• Compatible with Macintosh OS system.

I. Package Content:

1. SC-P20 Wireless Joystick Keyboard

2. Mini USB RF Receiver

3. 2 AA Batteries

4. User Guide

II. System Requirements:

1. IBM or compatible system

2. WIN 98SE/2000/ME/XP

Summary of content (4 pages)

PAGE 1
ENGLISH Scorpius-P20 2.4GHz Wireless Joystick Keyboard User Guide Introduction Thank you for purchasing Scorpius-P20 2.4GHz Wireless Joystick Keyboard. For an ideal performance, please follow the instructions of this user guide. If you have any question, please contact us at www.ione.com.tw or www.itron-europe.com Scorpius-P20 combines mouse and keyboard functions in one device with advanced technology to work with your media center system. This is a plug and play device under Win ME/2000/XP.
PAGE 2
3. Mac OS system III. Definition of panel information: Signal Indicator Description Connect Button Reset button for new ID or bad connection Transmitter Orange Indication of RF transmitting status FN Green Activation of “numerical keypad” function button Battery Low LED on RF receiver Red Indication of “Battery Low” status Orange Indication of RF receiving status. Red Indication of “Battery Low” status. IV. Hardware Setup Notice: 1.
PAGE 3
receiver will start to blink. Step 3: Within 8 seconds, please press the “connect” on the keyboard. Step 4: The LED on the RF receiver will blink faster if the ID setting is completed. Step 5: If the keyboard does not work properly, please go back to step 2 and repeat step 2 to Step 4.
PAGE 4
NOTE This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiated radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.