User's Manual

ManualsBrandsIone International ManualsElectronicsReceiver

Optical Mouse User Manual：

LYNX-R15W

2.4GHz Wireless Optical Trackball Mouse

INTRODUCTION

LYNX-R15W lets you experience the convenience of fingertip optical control

and the beauty of modern design. It is designed with a large trackball

which improves control while reducing hand and wrist motion. Please be

ready to experience effortless Web navigation that results from accurate,

finger-operated control!

I. Package Contents

 2.4GHz Wireless Optical Trackball Mouse

 Receiver

 USB Charger Cable

 User Guide

II. System requirements

 IBM or Compatible PC System

 Microsoft Windows XP / Vista / 7 / 8

III. Hardware Installation

 ID setting

The product has been pre-set and the mouse and USB receiver are

already paired. It is not necessary to do the ID setting when you use the

mouse for the first time. However, the connection may be lost due to RF

interference of environment. Hence it may be necessary to re-set the

connection ID. Please follow the process below for the ID setting.

Summary of content (6 pages)

PAGE 1
Optical Mouse User Manual： LYNX-R15W 2.4GHz Wireless Optical Trackball Mouse INTRODUCTION LYNX-R15W lets you experience the convenience of fingertip optical control and the beauty of modern design. It is designed with a large trackball which improves control while reducing hand and wrist motion. Please be ready to experience effortless Web navigation that results from accurate, finger-operated control! I. Package Contents  2.
PAGE 2
Step 1：Plug the USB receiver into your computer. Step 2：Keep pressing the mouse right button to register the ID setting process. Step 3：The LED on the mouse will shows green light and into connecting mode within 13 seconds. Step 4：After step 2, release the mouse right button, ID setting is completed. Note：If the Wireless Mouse do not work properly, please go back to step 2.  Charger Mode： Step 1：Use the USB cable connecting to the mouse and PC device.
PAGE 3
 KEY DEFINITION： 1 ○ Left Click 3 ○ Trackball 2 ○ 4 ○ Right Click Scroll wheel
PAGE 4
 MODEL LABEL LYNW-R15W： RECEIVER： This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation.
PAGE 5
B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation.
PAGE 6
Operational description The Principle of Receiver There are 2 IC chips inside an receiver. SN8P2271B as an USB IC, it transform the signal into USB signal or encoded RF signal. nRF24L01+ is RF IC, it transfer and receive RF signals. When RX received signals from TX, the signal will be decoded and then transfered to USB IC, the USB IC will then transform it into USB CODE and send it to PC.