User's Manual

A. Quick Reference Guide for RF
Wireless Mouse
Thank you for purchasing the RF wireless
Mouse. This features of the mouse have three
keys and twenty self setting programmable
functions. This guide gives you what you need
to get started right away. After you have
finished installation, refer to the electronic
user’s guide on the software driver to learn
more about your product. Please follow the
instructions below:
I. Components and Features:
1. Features:
RF wireless mouse
Advance 3 buttons design with ergonomic
styling
Security ID: 256 set ID
21 different multimedia functions
2. Package Contents:
RF wireless Mouse
Receiver
2AA batteries
Driver Diskette
USB extended line
UP Adaptor
II. Hardware Installation
1. Turn off your computer.
2. Insert the mouse connector PS2 (or USB) to
PC Mouse port
3. Insert batteries
Insert provided batteries in mouse.
Refer to diagram inside battery
compartment.
4. Power on your computer
III. ID Set
IV. Software Installation:
Turn on your computer and run either
Windows 98 / 2000 / ME / XP.
1. Insert the program setup disk into driver A
(or B).
2. Start
Execute A:\SETUP.EXE
Choose " Extract" Choose "USB or
PS2" port
“OK”.
3. Follow the setup program's on-screen
instructions. (Below is the setup process.
Please follow the screens to install.)
4. Programmable functions menu:
Reset ID before using
Step 1: Connect the receiver to your computer
Step 2: Push the “CONNECT” button on the
receiver. The LED will start to blink.
Step 3: Push the button on the back of the
mouse (in upper left corner). Please
note that this step must be completed
after Step 2 within 8 seconds.
Step 4: When the receiver and the mouse are
connected, the LED will blink faster for
a while, it means the set has been
completed.
Step 5: Please go back to Step 2 if the LED does
not behave as that in Step 4.
Note: If same ID is used by other users and
causes interference, just repeat this
reset procedure.
RF Lynx Mouse & RF Lynx Receiver
Lynx-MVII & Lynx-MVII-R
User’s Manual
1 2
25-100-566