Users Manual Part 4

ManualsBrandsio ManualsElectronicsDual band 4X4 lndoor Access Point (AP) with integrated antenna

Indoor & Outdoor Access Points Revision: A0-09

104

CONFIDENTIAL

21.3 Outdoor Access Point mounting onto the Pole

To mount the device on a pole, an extra clamping bracket is needed along with the mounting bracket. Follow the steps

given below and mount the device on pole:

1. Attach the mounting bracket to the back side of the Access Point as shown in “Figure 79: Mounting bracket

alignment with the 4x4 outdoor AP”.

2. Firmly place the mounting bracket on the pole (make sure there is no movement) and attach the clamping

bracket with M5-expansion bolts.

Figure 81: Overview of the 4x4 outdoor AP with pole and clamping bracket

Summary of content (7 pages)

PAGE 1
Indoor & Outdoor Access Points 21.3 Revision: A0-09 Outdoor Access Point mounting onto the Pole To mount the device on a pole, an extra clamping bracket is needed along with the mounting bracket. Follow the steps given below and mount the device on pole: 1. 2. Attach the mounting bracket to the back side of the Access Point as shown in “Figure 79: Mounting bracket alignment with the 4x4 outdoor AP”.
PAGE 2
Indoor & Outdoor Access Points 3.
PAGE 3
Indoor & Outdoor Access Points 21.4 Revision: A0-09 Outdoor Access Point mounting onto the Wall To mount the device onto the wall, M5-expansion bolts and foundation bolts are needed along with the mounting bracket. Refer the image given below: Figure 83: Items needed for mounting the device to wall Follow the steps given below and mount the device onto the wall: 1. 2. 3.
PAGE 4
Indoor & Outdoor Access Points 4. Revision: A0-09 Push the foundation bolt into the drilled holes with a hammer. Refer the image shown below: Figure 84: Hammer foundation bolts into the wall 5. Align the drilled holes with the holes of mounting bracket.
PAGE 5
Indoor & Outdoor Access Points 6. Revision: A0-09 Insert M5-expansion bolts through the holes of mounting bracket into the foundation bolts as shown below: Figure 85: Basic overview of wall mounted 4x4 outdoor AP 7. The AP device is mounted on the wall.
PAGE 6
Indoor & Outdoor Access Points 21.5 Revision: A0-09 Grounding of AP The AP should be properly grounded upon installment. The IO’s 4x4 AP has a grounding position at the back side of the device as shown below: Figure 86: Grounding point of AP A grounding strap can be made from the ring lug terminal of M4 size and a medium length copper wire of suggested gauge AWG-6 (4.1 mm). Insert the grounding wire and flush it till the end of the terminal. Use the crimp tool and reshape or compress the terminal.
PAGE 7
Indoor & Outdoor Access Points Revision: A0-09 22 Use Cases A. Indoor Access Point Figure 87: Use Case Diagram of Indoor AP B.