Installation Instructions

ManualsBrandsInVue ManualsElectronicsLIVE Vertical Wireless

For technical assistance call

NA / LATAM // 704.752.6513

•

888.55.INVUE

EMEA // +31.23.8900150

APAC // +852.3127.6811

Wireless Zone Manager DBD702 & Optional LED Emitter DBD703

If installing the optional LED

Emitter (DBD703), plug that

into the 3-pin port in the

Zone Manager

Determine your range

settings by consulting the

illustration to the right for

guidance. Turn the knob to

the desired setting by hand

or using the key fob tool

included with a OneKEY.

Note: All distances are approximate. The shape and distance of the eld can be

altered by ferrous objects near the Zone Manager (such as structural steel pillars).

The eld also extends upwards. Keep these factors in mind when installing and

setting the range of the eld.

Consult the following graphics

to determine your Mode

settings. Turn the knob to

the desired setting by hand

or using the key fob tool

included with a OneKEY.

MODE SETTINGS

Alarm starts when sensor enters Alarm Zone.

Alarm Zone

Warning Mode

Alarm stops when it leaves Alarm Zone.

Continuous Mode

Alarm continues until it times out.

Alarm stops according to chosen mode:

Alarm starts when sensor leaves Secure Zone.

Secure Zone

Alarm stops when it re-enters Secure Zone

or when it times out.

Plug the power supply into

the 2-pin port in the Zone

Manager.

Summary of content (4 pages)

PAGE 1
Wireless Zone Manager DBD702 & Optional LED Emitter DBD703 1 Determine your range settings by consulting the illustration to the right for guidance. Turn the knob to the desired setting by hand or using the key fob tool included with a OneKEY. 2 Consult the following graphics to determine your Mode settings. Turn the knob to the desired setting by hand or using the key fob tool included with a OneKEY.
PAGE 2
Wireless Zone Manager DBD702 & Optional LED Emitter DBD703 0 (meters) 1 2 3 5a 8 Determine how the Zone Manager will be mounted. • If using the adhesives, clean the area where the Zone Manager will be mounted. • If mounting to a wall using the 8mm screw holes, the holes are set 8 15/16 inches (225 mm) apart center to center. Place the Zone Manager where desired and apply pressure for at least 10 seconds. 5b If threading hardware into the M4 x 0.
PAGE 3
Wireless Zone Manager DBD702 & Optional LED Emitter DBD703 12 Peel the clear film from the adhesives on the LED Emitter. 13 14 Place the LED Emitter in the predetermined location and apply pressure for at least 10 seconds. 3 The LED Emitter will illuminate. For technical assistance call NA / LATAM // 704.752.6513 • 888.55.INVUE EMEA // +31.23.8900150 APAC // +852.3127.
PAGE 4
Wireless Zone Manager DBD702 & Optional LED Emitter DBD703 LIVE Vertical Wireless Model: ZNMGR30 Hereby, InVue Security Products, Inc. declares that the radio equipment type ZNMGR30 is in compliance with Directive 2014/53/EU. The full text of the EU declaration of conformity is available at the following internet address: https://invue.com/product-compliance/ EU Importer: INVUE SECURITY PRODUCTS B.V. Saturnusstraat 17 D 2132 HB Hoofddorp The Netherlands +31 23.