Quick Guide

QUICK GUIDE
WARNING ON THE BATTERY OF THE PRODUCT
Fully charge the battery before using the product for the
rst time.
Do not store the Product without charging it. Failure to do so may cause irreversible da-
mage to the battery capacity. Charge the battery every TWO months.
WARNING ON THE WATER RESISTANCE OF THE PRODUCT
The control unit, connected to the audio kit , can be immersed in a metre of fresh water
for a maximum of 30 (thirty) minutes.
Despite this classi
ation, the device is not immune to greater stress, such as prolonged
immersions or high pressure water jets.
Using the product during intense meteorological phenomena, at high speeds, may be
equivalent to subjecting the product to a high pressure jet.
FOLLOW ALL SUGGESTIONS CAREFULLY TO AVOID DAMAGING THE DEVICE:
Do not immerse the product in fresh water which is more than a metre deep for more than
30 minutes.
Do not store th
e product when still wet: dry it with a clean, so
cloth. Dry any water or moi
-
sture present in the connector of the control unit and/or audio kit with hot air for at least 10
minutes, so as to prevent the oxidation of the contacts.
Do not expose the product to salt water or ionised water, drinks or other liquids.
If the device is exposed to liquids other than fresh water, wash the device with cold fresh
water and dry it carefully with a clean, so cloth.
Do not expose the product to high pressure water jets.
Make sure that the audio kit connector is completely inserted in the control unit.
If not, complete protection against water and dust is not guaranteed.
CHAPTER 1 – COMPOSITION OF THE KIT
Microphone for full face helmet
Speaker kit
USB cable for charging and data
Velcro and spare sponges
Phone
Bluetooth unit
Volume +
Volume -
Music
FM Radio
Up (<)
Down (>)
Clamp bracketAdhesive bracket
CHAPTER 2 – INSTALLATION INSTRUCTIONS
Locate the area in correspondence
with the ear
If possible, remove the two
cushions or padding
Position the strips of Velcro
for the speakers
Filp-up/jet helmet Full face helmet
Choose the microphone to use:
Place the speakers
1
3
2
4
5
(!) Warnings on installation:
1. The centre of the speakers must be placed
in correspondence with the ears, as close as
possible.
2. The marking “MIC” on the microphone
must be directed towards the mouth.
Adhesive bracket
Re-install the cushions
Clamp bracket
Install the control unit and connect the cable
6
7
8
MIC
CHECK FOR SOFTWARE UPDATES ON WEBSITE
www.interphone.com
BTF10