ASSEMBLY INSTRUCTIONS Description : HALL CUPBOARD RTA Item No. : CU-160 ITEM NO.
BEFORE ASSEMBLY Thank you for purchasing this quality product. This product has been designed for easy assembly and constructed for durability. All parts were checked prior to packaging to insure quality. Prior to beginning assembly, however, make sure all parts and hardware are included and free of obvious defect. If a part is missing or defective, please contact the store where purchased. If hardware is missing, or you need help with assembly, please call toll free 888-944-8396.
PART LIST When unpacking, please be careful not to discard any parts with the packaging. Before continuing, please make sure you have the following parts: NO Description Qty A Top C E Sketch NO Description Qty 1 B Door 2 Side panel (L-R) 2 D Adjustable shelf 2 Back panel 1 F Bottom panel 1 ITEM NO.
HARDWARE LIST When unpacking, please be careful not to discard any parts with the packaging. Before continuing, please make sure you have all of the following hardware: NO Description Qty 1 Bolt (M6 x 35mm) Sketch NO Description Qty 8 2 Lock washer (M6.5 x M11) 8 1 3 Flat washer (M6.5 x M19) 8 4 Long screw (M4 x 35mm) 5 Short screw (M3.5 x 15mm) 22 6 Short pan head screw (M3.
STEP 1 Attach side panels (C) to top (A) and bottom panel (F) with bolts (1), and washers (2) and (3) as shown below. Tighten with Allen key (7). STEP 2 Slide back panel (E) into grooves of side panels (C), then attach back panel (E) to top (A) and bottom panel (F) with pan head screws (6) as shown below. Tighten with a screwdriver. ITEM NO.
STEP 3 Attach doors (B) to the unit with screws (5) as shown below. Tighten with a screwdriver. STEP 4 Attach knobs (8) to doors (B) with pan head screws (9) as shown below. Tighten with a screwdriver. Attach brackets (11) to side panels (C) as shown below. Then place the adjustable shelves (D) on brackets and attach with screws (5). Tighten with a screwdriver.