Manualshelf

User's Manual

ManualsBrandsIntermec Technologies ManualsComputers & AccessoriesMobile Computer
1234
CK3R
/
C
K3X
Mobile
C
o
mputer
Compliance
Insert
Models
1007CP
0
1
,
1
007CP
02
,
1007CP02L,
1
007CP
02-NI
ME04
Complies
with
IDA Standards
DA 102905
For Users in English-Speaking Regions
(en)
Intermec Model 1007CP02 is available certified for use in typical commercial
environments
as well as an
optional
version, Model 1007CP02
-
NI, certified for use in Division 2
hazardous locations
in
the
United States and Canada. This
document
addresses
both
use
environments. Th
e
additional precautions
for safe use of
the
Division 2 rated version are at
the
end of this
docum
e
n
t
.
Ca
u
t
ion
:
This marking indicates that the user should read all included
documentation
before use. Retain this
supplement
for
fu
t
ure
re
fe
rence
.
Users of this
product
are cautioned to use accessories and peripherals approved by Intermec Technologies
Corporation.
The use of ac
ce
ssories
other than those recommended, or changes to this
product that
are not approved by Intermec Technologies
Corporation,
may void
t
he
compliance of this
product
and may
result
in the loss of the
us
er
’
s
au
thor
i
t
y
to
operate
the
e
qui
p
ment.
Battery, Charger, and Power Supply
Information
Caution: For use
with
Intermec battery pack Models
AB17, AB18, 1001AB01,
or 1001AB02 only. See battery
instructions.
For
p
o
w
e
r
supply, use PhiHong model
PSA10F-050Q-R
(Intermec P/N 851-099-001). No user-serviceable
par
t
s.
Charge only in or with Intermec model
AC20,
AD20, AD21, AD22, or
AA23
with
AE23
charger
;
or with Intermec base 1002UU01
,
1002UU04 or 1002UU05 using Intermec adapter 1002UD02 or 1002UD05. Use of
incorrect
charger may present a risk of fire
o
r
explosion.
Promptly
dispose of used
battery
pack according to
the in
stru
c
t
i
o
n
s
.
Ca
u
t
ion
:
The
battery
pack used
with this product
may ignite, create a chemical burn hazard, explode, or release toxic materials if
mistreated.
Do
not
incinerate, disassemble, or heat above 100 °C (212 °F). Do
not short
ci
rc
ui
t
;
may cause burns. Keep away f
r
om
ch
il
dr
en
.
Battery Recycling
Information
Li-ion
Li-ion
This
product
contains or uses a
lithium-ion
(Li-ion) main battery. When the
battery
reaches the end of
its
useful life, the spe
nt
battery should be disposed of by a qualified recycler or hazardous
materials
handler. Do
not
mix this
battery
with the soli
d
waste
stream.
Contact your Intermec Technologies
Service
Center for recycling or disposal
in
f
orm
a
t
ion
.
80
2.
11
Radio Precaution
S
t
a
t
emen
t
Ca
u
t
ion
:
Users are responsible for configuring
the
channels of
operation that
comply with their country regulatory standards. A
Wireless
Network Administrator
should
review
the operating restrictions
detailed within
the
Access
Point installation man
u
al
.
Radiation Exposure
S
t
atem
en
t
Warning: This
equipment
complies with
International
Commission on Non-Ionizing Radiation Protection (ICNIRP), IEEE C95.1,
Federal
Communications
Commission Office of Engineering and Technology (OET) Bulletin 65, Canada
RSS-102,
and
European
Committee
for
Electrotechnical Standardization
(CENELEC)
limits for exposure to radio frequency (RF)
radia
t
ion
.
For CK3R (Model 1007CP01)
:
If a body worn accessory is
not
purchased from Intermec,
the
accessory must contain no
metal
and provide a
1.0
cm
(0.39
in) space between the device and the
bo
d
y.
For
CK3X
(Model 1007CP02 & 1007CP02L)
:
If a body worn accessory is
not
purchased from Intermec, the accessory must contain no
metal
and provide a
1.0
cm
(0.39
in) space between the device and the
bo
d
y.
Use of antennas and accessories
not authorized
may void the compliance of this
product
and may result in RF exposures beyond
the limits
established for
this equipment.
To find RF exposure
information,
go to www.intermec.com > Products > Computers >
H
a
ndheld
Computers > CK3 > Manuals
tab,
and then scroll down to Regulatory
Inform
at
io
n
.
U.S.A. and
Can
ada
Laser Compliance and P
r
e
c
au
ti
on
The 1007CP01, 1007CP02, 1007CP02L, and 1007CP02-NI are registered with the CDRH as a Class II
LASER
Product (21 CFR
Subchapter
J,
Part
1040). This
product
has a maximum
output
of 1 mW at 630-680
nm.
Caution: There are no user
serviceable
parts
inside the 1007CP01, 1007CP02, 1007CP02L, or 1007CP02-NI. Use of controls
o
r
adjustments,
or performance of procedures
other
than those specified herein, may result in hazardous laser light exposure of up
to
1 mW
at
630-680
nm.
Note
:
There are no controls or
adjustments
provided for routine
operation
or
maintenance
of the 1007CP01, 1007CP02, 1007CP02L,
or
1007CP02-NI.
1

Summary of content (4 pages)