User Manual

-------------------------------------- DRAFT COPY --------------------------------------

Instructions for Model HA03 – Indoor Plug-in Lamp Dimmer – using the HA07

Controller

User’s Manual

*Illustration of HA03 Dimmer Module*

General Description

Federal Communications Commission Statement

This device complies with part 15 of the FCC rules. Operation of this device is subject to

the following two conditions: (1) This device may not cause harmful interference, and

(2) This device must accept any interference, including interference that may cause

undesired operation.

NOTE: This equipment has been tested and found to comply with the limits for a Class

B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to

provide reasonable protection against harmful interference in a residential installation.

This equipment generates, uses and can radiate radio frequency energy and, if not

installed and used in accordance with the instructions, may cause harmful interference to

radio communications. However, there is no guarantee that interference will not occur in

a particular installation. If this equipment does cause harmful interference to radio or

television reception, which can be determined by turning the equipment off and on, the

user is encouraged to try to correct the interference by one or more of the following

measures:

-- Reorient or relocate the receiving antenna or device.

-- Increase the separation between the equipment and receiver.

-- Connect the equipment into an outlet on a circuit different from that to which the

receiver is connected.

-- Consult the dealer or an experienced radio/TV technician for help.

WARNING!

Changes or modifications not expressly approved by the party responsible for compliance

could void the user’s authority to operate the equipment.

Enclosed you will find:

1 Indoor Plug-in Lamp Dimmer (for use with HA07, HA09, or any Z-wave enabled

remote controller)

Installation Instructions

Plug-in Dimmer:

1. Plug the lamp dimmer into a powered, 125VAC outlet.

2. Plug the lamp you wish to control into the lamp dimmer receptacle. Maximum

rating of the lamp should not exceed 300 Watts

Remote Controller

PAGE 1
-------------------------------------- DRAFT COPY -------------------------------------Instructions for Model HA03 – Indoor Plug-in Lamp Dimmer – using the HA07 Controller User’s Manual *Illustration of HA03 Dimmer Module* General Description Federal Communications Commission Statement This device complies with part 15 of the FCC rules.
PAGE 2
1. Open the battery compartment located on the back of the remote controller by pressing down on the battery compartment tab and pulling the door outward. 2. Insert 4 “AA” alkaline batteries (not included) with polarities as shown. 3. Replace the battery compartment by first inserting the 2 tabs at the bottom of the door, then pressing the door in until the door ‘clicks’ shut. Operating Instructions Creating a Network 1. On the remote controller, the include button is located behind a protective lid.
PAGE 3
Suitable for indoor use only. This device complies with part 15 of the FCC rules. Operation of this device is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference, including interference that may cause undesired operation. For control of incandescent luminaries only. Pour commande de luminaries a incandescence seulement.