Use and Care Manual

From inside the battery holder,

slightly bend the battery contacts

t d ith t th i k ll

DT620

Unplug the DT620 from the outlet.

This WI is Applicable to the DT620 2-Outlet Digital Timer

Use the end of a non-metallic object,

such as a pen, to pry the battery

holder open.

Work

Instruction

If you are replacing the batteries, pry

loose the batteries with an end of a

paperclip.

Battery

Installation/Replacement

Apply

grease.

Insert the other battery, plus side

down, on top of the installed battery.

With the prongs facing outward and

the holes on the side of the holder

facing you, insert a new battery (plus

side down), into the battery holder

(plus side on bottom).

outward with a toothpick or small

paperclip to increase tension on the

new batteries.

1 of 2

WI-000001

Denotes important check/inspection step

Denotes any potential injury or damage to

the equipment

Revision

Page

5 6

PAGE 1
Work Instruction DT620 This WI is Applicable to the DT620 2-Outlet Digital Timer 2 1 Battery Installation/Replacement 1 2 3 4 5 6 Unplug the DT620 from the outlet. Use the end of a non-metallic object, such as a pen, to pry the battery holder open. 3 4 If you are replacing the batteries, pry loose the batteries with an end of a paperclip. Apply grease.
PAGE 2
Work Instruction 7 DT620 Battery Installation/Replacement 1 7 Insert the holder into the timer with the plus and minus indicators facing the electrical prongs on the timer.