Installation Manual

© 2018 United Technologies Corporation. All rights reserved. P/N 1073413-EN • REV A • ISS 24JAN18
Interlogix is part of UTC Climate, Controls & Security, a unit of United Technologies Corporation.
TVJ-JBS Stainless Steel Junction Box
Installation Instructions
Specifications
Dimensions
:
248.7 × 174 × 77.5 mm
(9.79 × 6.85 × 3.05 in.)
210 mm (8.27 in.)
248.7 mm (9.79 in.)
229 mm (9.02 in.)
135 mm (5.31 in.)
60 mm
(2.36 in.)
141 mm
(5.55 in.)
174 mm
(6.85 in.)
77.5 mm
(3.05 in.)
123 mm (4.84 in.)
Weight:
1981 g (4.37 lb.)
A
ccessories:
Drill template: 1
pcs
Screw
: PA5 x 25 mm (4 pcs)
Used to install the TVJ
-JBS stainless steel junction box to the
mounting
surface.
Drywall anchor: 7.5 x 24.5 mm (4
pcs)
Used to install the TVJ
-JBS stainless steel junction box to the
mounting
surface along with the screw described above.
Torx w
rench: 1 pcs
Used to remove and
tighten the Torx screws on the cover of the
stainless steel junction box.
Sealing plug group A: 4
pcs
Used for the
camera cable harness access hole. Plug color
depends on cable diameter. Use the correct color for a tight seal.
Black White Blue Black
Sealing plug group B: 4 pcs
Used for the other two holes.
Plug color depends on cable
diameter. Use the correct color for a tight seal.
Black White Blue Black
Supported Cameras
The stainless steel junction box can be used with following
cameras:
Stainless Steel Dome: TVD-5801, TVB-5802
Installation
To install the junction box:
1. Drill mounting holes in the mounting surface according to
the supplied drill template. Insert the four drywall anchors
in the mounting surface. Partially tighten down the four
mounting screws