Installation Instructions

Multi-Purpose Housing Installation Instructions
Product summary
The Multi-Purpose Housing (60-928) is designed to hold
several different circuit boards. It can be adapted for many
different installation situations. The Multi-Purpose Housing has
the following features:
• Space for an optional backup battery.
• Holes for an antenna
• Temporary supports for pre-wiring of boards.
• Wiring knockouts.
• Combined wall/cover tamper protection.
Figure 1: Multi-purpose housing features
Optional
Backup
Battery
Optional
Antenna
Holes
Wall/Cover
Tamper
Adjustable Board
Supports
Temporary
Supports (Pre-
Wiring)
Circuit Board
Supports
Wiring
Knockouts
Wiring
Knockouts
Accessory kit
The Multi-Purpose Housing comes with the following
accessories:
• Two screws for adjustable supports.
• One Tinnerman nut for the cover locking mechanism.
• Anchors and screws for mounting
• One screw for the cover locking mechanism.
• Two silicone caps for antenna holes and mounting of loop
antenna.
• Two rubber o-rings for plastic antenna housings.
• One normally closed tamper switch with spring.
Installing 6 in. (15.24 cm) circuit boards
1. Remove the adjustable board supports from the housing.
2. Remove the appropriate wiring knockout.
3. Attach housing to wall.
Note: Be sure adjustable board supports and knockouts are
removed before mounting the housing.
4. Place board in temporary support.
5. Wire the board as needed.
6. Place the board on appropriate supports.
7. Position adjustable board supports as needed for board
size (See the following figures).
8. Attach supports with screws.
Figure 2: Installation of 2.3 x 6 in. (5.83 x 15.24 cm) circuit board
2.30 in
(5.83 cm)
6.00 in
(15.24 cm)
Figure 3: Installation of 3.3 x 6 in. (8.56 x 15.24 cm) circuit board
6.00 in
(15.24 cm)
3.37 in
(8.56 cm)
P/N 466-1959 • REV D • January 2011 1