Installation Instructions

ManualsBrandsInterlogix ManualsElectronicsShatterPoint Residential Glassbreak Sensor

ShatterPoint Glassbreak Sensor

Mounting

Description

The 5600 Glassbreak Sensors are designed to detect

breaking glass caused by forced entry into a protected

window or door. The ‘Tru-Dual’ transducer design provides

excellent false-alarm immunity in noisy environments.

The 5600 Sensors process both acoustic and vibration

information to identify breaking windows. Frame mounting

the 5600 Sensors eliminates detection concerns with drapes

and blinds. The built-in reed switch models provide

protection against forced opening of windows or doors, as

well as breaking glass.

Note These sensors may not consistently detect

cracks, bullets, or similar breaks. Glassbreak sensors

should always be backed up by interior protection such

as a motion detector.

Figure 1a. Frame Mounting

The 5600 sensors are designed to mount either inside the

frame (see Figure 1a) or on the facing (see Figure 1b). Refer

to Figure 3 for recommended mounting locations and

coverage range. The mounting location should provide good

mechanical coupling from glass to sensor and an

unobstructed microphone view of the glass. If structural

integrity of the frame is poor, temporarily mount the sensor

and follow the steps in Testing for range testing. Do not

exceed the tested range of the sensor.

Note For applications with more than one framed

window, use multiple 5600s or a ShatterPro II.

Use the screws provided to mount the sensor securely to the

frame. A loosely mounted sensor will not perform correctly.

The small cover screw must be used to permanently attach

the cover (see Figure 2).

ShatterPoint

™

Glassbreak Sensor

Models

5600-W, 5605-W, 5620-W, 5625-W

Installation Instructions

Figure 1b. Facing Mounting

Figure 2. Mounting and Cover Screws

Cover Screw

Summary of content (4 pages)

PAGE 1
ShatterPoint™ Glassbreak Sensor Models 5600-W, 5605-W, 5620-W, 5625-W Installation Instructions Figure 1a. Frame Mounting Description The 5600 Glassbreak Sensors are designed to detect breaking glass caused by forced entry into a protected window or door. The ‘Tru-Dual’ transducer design provides excellent false-alarm immunity in noisy environments. The 5600 Sensors process both acoustic and vibration information to identify breaking windows.
PAGE 2
Picture Window Vertical Slide Horizontal Slider Double Slider Double Hung Patio Door Hinged Casement Figure 3. Mounting Locations Reed Switch Models Models 5620 and 5625 require the magnet be mounted on the moving portion of the window or door. Magnet placement must be within 3/4" (19mm) of sensor, either behind or below (see Figure 4). Center magnet as marked on the printed circuit board (see Figure 5). Wiring The 5600 sensor provides multiple wiring entrances (see Figure 6).
PAGE 3
End-User Test Simply clap hands within 3 feet (1m) of the sensor and the LED will flash quickly indicating the sensor is powered and functioning properly. Testing The 5600 features installation tests and a hand-clap end-user test. Installation Test The sensor is ready to test once installed with cover on and powered, no test mode is necessary. To test sensor, perform range testing to ensure adequate vibration coupling to sensor. After range is verified, perform alarm test.
PAGE 4
Specifications Dimensions Voltage ..................................................................... 9 – 16V DC Current .............................................. 12mA typical, 20mA max. Relay Output: Normal ......................................... <15 W (closed) Alarm ............................................................ >1 MW (open) Open 4 seconds upon alarm Maximum loop rating .................................. 16V DC, 50mA Wire Terminals .................................................