EKO Extreme W240 Extreme W240 USER MANUAL Page 1
EKO Extreme W240 Know Your Phone OK KEY Enter into the main menu, Long press to on/off the torch. Left soft key Enter main menu in idle mode. Press left soft key, then press * to lock/unlock the key pad Dial key Dial and receive a call. View All calls in the standby mode. Number keys Enter numbers, letters or characters. * key Press to select punctuations when writing message Right soft key Access the Contacts list menu in idle mode. Return to previous menu.
EKO Extreme W240 Batteries The battery is included in the package. It is not fully charged out of factory but it may still be able to power on your phone. Please completely use up the power of the battery and then charge it for at least 12 hours with your phone turned off. You battery will reach its optimal state after three cycles of charge and discharge. Installing and uninstalling the battery To install the battery, remove the back cover from the phone by pressing firmly on the cover and slide it down.
EKO Extreme W240 Battery level indicator When the phone is on, the battery level indicator is located at the upper right corner of the screen. Connecting to the Network SIM card Please insert available Subscriber Identity Module (SIM) card into your phone before using it. SIM card is supplied by your network carrier. All the information related to network connection is recorded on the SIM card, so are the contact information such as names, phone numbers and SMS that you set to store on the SIM.
EKO Extreme W240 source. Fit the SIM card into the SIM card slot. Align the angled corner of the SIM card with the slot. Slide in the SIM card, make sure it is in place, install the battery, and restore the back cover. Likewise, to remove the SIM card, switch off the phone, remove the battery and then take out the SIM card. Unlock the SIM card PIN code Your Personal Identification Number (PIN/PIN2) code protects the SIM card against unauthorized use.
EKO Extreme W240 Basic Operations Switch Phone ON/OFF To switch ON/OFF your phone, press and hold the End key for a few seconds. Unlock the phone If you do not use the phone for a while, the screen is replaced with a locked screen. 1. Press any key to activate the screen. 2. Press Unlock key, and then press * key. Make a call You can make a call in the following ways: Enter the desired number in standby mode and press the Call key to make the call.
EKO Extreme W240 [Wallpaper settings] Set wallpaper [Idle display setting] Set the idle [Contrast] adjust the screen's backlight brightness [Backlight] Set the backlight time screen [Keypad backlight time] Set the backlight time key 【Security】 [PIN] Select open or modify the phone's PIN code [Modify PIN2] PIN2 choose to modify the phone code [Phone locked]: Set the phone locked [Change phone password]: Modify the password of phone [Date security] set access to enter the password to view functionality.
EKO Extreme W240 Disclaimers 6. The colors and specifications shown/mentioned in the user manual may differ from the actual product. Images shown are for representation purpose only. Other product logos and company names mentioned herein may be trademarks or trade names of their respective owners. 7. EKO keeps the right to make modifications to any of the content in this user guide without public announcement in advance.
EKO Extreme W240 equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation.
EKO Extreme W240 For body worn operation, this device has been tested and meets the FCC RF exposure guidelines when used with an accessory designated for this product or when used with an accessory that contains no metal and that positions the handset a minimum of 5 mm from the body. Non‐compliance with the above restrictions may result in violation of RF exposure guidelines.