OPERATING MANUAL R E M O T E MICROPHONE RM-01
SAFETY INSTRUCTION In order to correct operation this unit, keep away this microphone from following places. • Avoid placing it in direct sunlight or close to a source of heat, such as heater, stoves or other appliance that produce heat. • Also avoid location subject to vibration and excessive dust. • Keep away from magnetized appliance. • This microphone should be situated so that its location or position does not interfere with its proper ventilation.
NAME OF STAND ASS’Y ? ? ? ? ? ? ? 1. RUBBER FOOT This rubber foot of stand avoid sliding on the glass or table. 2. STAND This stand made of heavy Zn diecasting which can minimize touch noise. 3. STAND COVER 4. RECEPTACLE Input signal through 3p connector of goose neck becomes sound at this part of stand ass’y. 5. TALK SWITCH After press talk switch, the microphone does work and press again is off. 6. TERMINAL BLOCK This block is connected with remote chime.
BLOCK DIAGRAM SPECIFICATIONS • POLAR PATTERN .....................................................................................................UNIDIRECTIONAL • TYPE ...............................................................................................................MOVING COIL DYNAMIC • SENSITIVITY/ IMPEDANCE .......................................................–75, ±3dB(0dB=1V/Pa at 1KHz), 400Ω • FREQUENCY RANGE ...............................................................................