User's Manual

IS-TWL-DEBUGGER Ferrite Core Installation Exhibit
Ferrite Core Installation Exhibit
Steps
The following steps explain the install method for the IS-TWL-DEBUGGER hardware’s ferrite cores.
① As shown in the image, install a
large ferrite core near the
controller’s connector and fasten
it a cable tie. Cut off the excess
cable tie sticking out with
scissors.
② As shown in the image, install a
small ferrite core on the opposite
end of the controller’s connector
and fasten it with a cable tie. Cut
off the excess cable tie sticking
out with scissors.
③ Install a small ferrite core on the
USB cable. As shown in the
image, place the ferrite core
about 30cm from the B connector
where it is looped and the cable is
doubled.