User's Manual

ManualsBrandsIntegrated Display Technology ManualsElectronics2.4GHz FHSS Cordless Phone w/ CID, Radio & MP3

Important Saftey Instruction

Some of the following information may not apply to your

particular product; however, when using conference phone

equipment, basic safety precautions should always be followed

to reduce the risk of fire, electric shock and injury to persons,

including the following:

1. Read and understand all instructions.

2. Follow all warnings and instructions marked on the

product.

3. Unplug this product from the wall outlet before cleaning.

Do not use liquid cleaners or aerosol cleaners. Use a

damp cloth for cleaning.

4. This product should not be used while you are in a

bathtub, shower or pool. Immersion of the product in

water could cause an electrical shock.

5. Slots and openings in the cabinet back or bottom are

provided for ventilation, to protect it from overheating.

These openings must not be blocked or covered. The

openings should never be blocked by placing the

product on the bed, sofa, rug, or other similar surface.

This product should not be placed in a built-in

installation unless proper ventilation is provided.

6. This product should be operated only from the type of

power source indicated on the marking label. If you are

not sure of the type of power supply to your home,

consult your dealer or local power company.

7. Do not allow anything to rest on the power cord. Do not

locate this product where the cord will be abused by

persons walking on it.

8. Do not overload wall outlets and extension cords as this

can result in the risk of fire or electric shock.

9. Never push objects of any kind into this product through

cabinet slots as they may touch dangerous voltage

points or short out parts that could result in a risk of fire

or electric shock. Never spill liquid of any kind on the

product.

10. To reduce the risk of electric shock, do not disassemble

this product, but take it to a qualified serviceman

when service or repair work is required. Opening or

removing covers may expose you to dangerous voltages

or other risks. Incorrect reassembly can cause electric

shock when the telephone equipment is subsequently

used.

11. Do not expose the product to extreme temperatures

such as areas near a hot radiator or stove or in a hot car.

12. Do not place lighted candles, cigarettes, cigars, etc., on

the telephone.

13. Never touch uninsulated telephone wires or terminals

unless the telephone line has been disconnected at the

network interface.

14. Never install or modify telephone wiring during a

lightning storm.

15. Never install telephone jacks in wet locations unless the

jack is specifically designed for wet locations.

16. Use caution when installing or modifying telephone lines

to prevent electrical shock and/or fire.

17. Unplug this product from the wall outlet and refer

servicing to qualified service personnel under the

following conditions:

A. When the power supply cord or plug is damaged or

frayed.

B. If the product has been exposed to rain or water.

C. If the product does not operate normally by following

the operating instructions.

D. If the product cabinet has been damaged.

E. If the product exhibits a distinct change in

performance.

18. Avoid using a telephone (other than a cordless type)

during an electrical storm. There may be a remote risk of

electric shock from lightning.

19. Do not use the telephone to report a gas leak in the

vicinity of the leak.

20. Do not place this product on an unstable cart, stand or

table. The product may fall, causing serious damage to the

product.

21. Plug the adaptor to the socket-outlet which near the

equipment and shall be easily accessible.

22. Risk of explosion if battery is replaced by an incorrect

type, use on 3SN-AA120H-S-J1. Dispose of used

batteries according to the instructions

23. For servicing or replacement, you can purchase a

suitable headset through service center or retailer shop.

(see in www. oregonscientic.com)

SAFETY TIPS

This product is designed to give you years of service if handled

properly. Observe the following guidelines:

- Clean the unit with a damp cloth and mild detergent. Avoid

dropping the unit or placing it in a high-traffic location.

- Never immerse the unit in water. This can cause electrical

shock and damage the unit.

- Do not subject the Base Unit to extreme force, shock, or

fluctuations in humidity.

- Do not tamper with the internal components.

- Do not mix new and old batteries or batteries of different types.

- Remove the batteries if storing this product for a long period of

time.

- Do not scratch the LCD display.

- Do not make any changes or modifications to this product.

Unauthorized changes may void your right to use this product.

- The technical specifications for this product and the contents

of the user guide are subject to change without notice.

CAUTION

To reduce the risk of fire, use only

No. 26 AWG or larger

telecommunication line cord.

CAUTION

You must use a Class 2 power source that provide in

package. Its plug must fit the phone power jack. The supplied

adapter meets these specifications. Using an adapter that does

not meet these specifications could damage the phone or the

adapter.

Always connect the AC adapter to the phone before you connect

it to AC power. When you finish, disconnect the adapter from AC

power before you disconnect from the phone.

Under the environment with electrostatic discharge, the

captioned model may malfunction and require user reset.

SAVE THESE INSTRUCTIONS

Summary of content (17 pages)

PAGE 1
Important Saftey Instruction Some of the following information may not apply to your particular product; however, when using conference phone equipment, basic safety precautions should always be followed to reduce the risk of fire, electric shock and injury to persons, including the following: 1. Read and understand all instructions. 2. Follow all warnings and instructions marked on the product. 3. Unplug this product from the wall outlet before cleaning. Do not use liquid cleaners or aerosol cleaners.
PAGE 2
Music Box (Cube Phone) Model: CU328 USER MANUAL TABLE OF CONTENTS INTRODUCTION . . . . . . . . . . . . . . . . . . . . . . . . Key Features Handset – Front View Handset/Base – Back and Bottom View GETTING STARTED . . . . . . . . . . . . . . . . . . . . . Choosing a Base Unit Location Connecting the Base Unit Battery Set-up Charging Handset Batteries Low Battery Charging Handset Reception Handset LCD Symbols BASIC TELEPHONE FUNCTIONS . . . . . . . . . . .
PAGE 3
• • • • • • Adjustable ring tones (including MP3 ring tone), volume levels, language display, handset IDs and low-battery / out-of-range warning signals. Rechargeable batteries and up to 7-hours of continuous talk time.
PAGE 4
CHOOSING A BASE UNIT LOCATION When selecting a location for your base unit, please observe the following guidelines: • Choose a location that provides easy access to an AC power source and telephone jack. • Do not place the base unit near a sink, bathtub or shower, or close to heat sources. • Do not place the base unit near large metal objects or electronic appliances that may cause radio interference. CONNECTING THE BASE UNIT To connect the base unit: 1.
PAGE 5
OR Dial the number, then press . 1. 2. Press Press 3. Use , or the track ring to select . “Edit for Call”, then press / / and 0-9 buttons to edit the Use number. ANSWERING A CALL 4. The handset will ring when there is an external call. 5. To answer a call, press / / Press . . to dial the number. FAST REDIAL . To answer a call while music is playing, press . (The audio will pause automatically). When you make a call and hear the busy tone, / .
PAGE 6
7. Enter the phone number and then press / . The handset will beep twice indicating that the record has been stored. NOTE: If only a phone number and no name is input, then the record can still be saved. 4. 5. KEYS TO USE When entering a name, “B” will be entered by pressing the “2” button once, followed by pressing “2” again within 1 second. If pressed beyond 1 second, “A” is entered and the second press of “2” will give the entry of “AA”. [PLEASE LAY OUT IN CHART FORMAT] .
PAGE 7
3. 4. • Use , or the track ring to select “Edit for Call”. / and 0-9 buttons to edit the Use number. “REPT” – This appears when more than one call has been missed from this particular Caller ID. DURING A CALL 5. Press to dial the number. USING THE MUTE FUNCTION NOTE: If “No Calls” appears on the screen, then no records are stored in the Caller ID memory. To mute the handset, press NOTE: When the Caller ID memory is full, it will automatically delete your 1ST Caller ID record.
PAGE 8
5. Use the number keys to set the alarm time. 6. (Use , or the track ring to select hour or minutes to set). Press / to confirm. SETTING THE DISPLAY LANGUAGE To change the language: 1. Press / , then use , the track ring to select “Phone Setup”. 2. Press / , then use , or the track ring to select “Language”, then . press / Select the language you want, then press / to confirm. 3. or SETTING THE ALARM Your Cube Phone comes with dual alarm functionality.
PAGE 9
2. Select “Yes” or “No”, then press / . CONFERENCE CALLS You can have a conference call with an external party and 2 internal parties. To have a conference call: 1. First establish the call with the external party by either making an external call or answering an incoming call. 2. Press to make an intercom call to another handset. (The external party will be put on hold. The internal party answers your intercom call by pressing 3. ).
PAGE 10
2. On the handset, press 3. Use , or the track ring to select “Handset Setting”, then press / Select “Registration”, then press / . 4. 5. 6. 7. 8. / • • . Use , or the track ring to select “Base 1, 2, 3 or 4”, then press / . Enter the default Pin Code “0000” then press / . You will see the message: “Registering”. When the registration is complete, “Registration Success” will appear on the screen. DE-REGISTERING HANDSETS To de-register a handset from the base unit: 1. On the handset, press / . 3.
PAGE 11
NOTE: Before unplugging your player from your computer, wait at least 15 seconds after the audio or data file transfer is completed to prevent any data loss that may occur. MP3 BASIC OPERATION 2. . To fast forward through a track, press and hold To switch to MP3 Mode: / , then use Press to select “Goto MP3”. Press / . To stop a song, press . (This button is at the bottom of the silver volume ring). To pause a song, press SWITCHING TO YOUR MP3 PLAYER 1. To play a song, while in the MP3 Mode, press .
PAGE 12
EQ MODE VOLUME CONTROL You have a number of choices of how to equalize your music, including: • Classic – Affects sound to enhance all classical music. • Live – Affects sound to enhance all live music. • Pop – Affects sound to enhance pop music. • Rock – Affects sound to enhance rock music. • Normal – No audio settings set to enhance sound. To adjust the volume, move the track ring clockwise to increase the volume, or counter-clockwise to decrease the volume. To switch to EQ Mode while in MP3 Mode: 1.
PAGE 13
2. 3. 4. 5. Use or to select “Save Stations”. Press / . Once you are in Save Stations Mode, simply use or to select a channel from a list of ten stations (channels). Press / to save the selected radio station. DELETING A RADIO STATION To delete a radio station: 1. Press / . 2. 3. 4. 5. or Use Stations”. / Press to select “Delete . or to select a channel from Use the list of ten stations (channels). Press / to delete the selected station.
PAGE 14
2. Slide off the battery compartment cover. 3. Disconnect the battery plug from the jack in the compartment and remove the battery pack. 4. Insert the new battery pack and connect the cord into the jack. 5. Put the battery compartment cover back on. 6. Place handset on the base to charge the new battery for 15 hours. CAUTION: To reduce the risk of fire or personal injury, use a 3.6 V, 1200mAh battery. Contact your place of purchase.
PAGE 15
• • equipment and receiver. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Consult the dealer or an experienced radio / TV technician for help. CONSUMER INFORMATION a. b. c. d. e. This equipment complies with Part 68 of the FCC rules and the requirements adopted by the ACTA. On the bottom of this equipment is a label that contains, among other information, a product identifier in the format US:KT5W400BCU328.
PAGE 16
DECLARATION OF CONFORMITY "Hereby, Oregon Scientific declares that this Cube Phone (CU328) is in compliance with the essential requirements and other relevant provisions of Directive 1999/5/EC. A copy of the signed and dated Declaration of Conformity is available on request via our Oregon Scientific Customer Service.
PAGE 17
2.