User's Manual

Panic Button (PB-23)

The Panic Button is used to activate (or deactivate) a panic alarm.

z Parts Identification

1. LED Indicator

The LED indicator will light up briefly when the device is transmitting a signal.

2. Panic Button

1. Press to send a learn code or activate a panic alarm

2. Press and hold the button for 8 seconds to send a Cancel Code to the Control Panel. (This

function is not compatiable with every control panel).

3. Battery Compartment

4. 4 x Cover-Fixing Screws

5. Battery Insulator

z Battery

z The Panic Button is powered by one CR123A 3V Lithium battery.

z The Panic Button will transmit any detected low battery status along with any regular status

signal transmission to the Control Panel for display accordingly.

z When changing battery, after removing the old battery, press the button twice to fully discharge

before inserting new battery.

z Supervisory Signal

z The Panic Button will automatically transmit Supervisory Signals every 30 to 50 minutes.

z If the Control Panel has not received the signal from the Panic Button for a preset period of time,

the Control Panel will indicate that the Panic Button is out-of-signal range or is out of order.

z Getting Started

z Pull out the Battery Insulator to power on the Panic Button

z Put Control Panel into learn mode

z Press the button on the Panic Button to transmit a learn code.

z Refer to your Control Panel’s operation manual to complete the learn-in process.

z Walk Test

z Place the Control Panel in the walk test mode.

z Press the Button once.

z The Panel will display the RSSi (Radio Strength Signal) strength.

PAGE 1
Panic Button (PB-23) The Panic Button is used to activate (or deactivate) a panic alarm. z Parts Identification 1. LED Indicator The LED indicator will light up briefly when the device is transmitting a signal. 2. Panic Button 1. Press to send a learn code or activate a panic alarm 2. Press and hold the button for 8 seconds to send a Cancel Code to the Control Panel. (This function is not compatiable with every control panel). 3. Battery Compartment 4. 4 x Cover-Fixing Screws 5.
PAGE 2
z Operation z z z After the Panic Button is learned successfully, press the Button to activate a Panic Alarm. Press and hold the Button for 8 seconds or more will send a Cancel Code to the Control Panel to stop the alarm. (This function is not compatible with all control panels.) Installation A Pad is included into the Panic Button as picture shown below. The padding helps to avoid pressing the button accidently when mounting the Panic Button.
PAGE 3
Picture 5 z Surface Placement The Panic Button can be deployed on a flat surface without being installed at a fixed location. 1 Clean the back of the Panic button with degreaser. 2 Remove the protective cover of Anti-Slip pad and apply to the back of Panic Button. (Picture 6) Picture 6 3 Place the Panic Button at desired location. This device complies with Part 15 of the FCC Rules.