Specifications

FCC ID: XO8-HALOBLETX rev. 001
Instant Care Halo Transmitter
Model #: HALOBLETX-1
• Identifying the Parts
1
1. Emergency Button/ LED
• Learning-in the Halo Transmitter
Press the Emergency button, a Bluetooth Low Energy signal will be transmitted to the Control
Panel. Please refer to the learn-in procedure of your Control Panel for further instruction.
• Operation

To dial Emergency Line:
Press once on the Emergency button, the GREEN LED will illuminate briefly and transmit the
message to the Control Panel.
• Battery & Electrical Specifications

Frequency: 2.45 GHz

Battery: CR2032, 3V 230mAh

Battery life: Approximately 3 years

Open Field Range: Approximately 5.

Low battery status: when the battery voltage is below the threshold, the Halo Transmitter will
indicate a low battery by illuminating the RED LED for .5 seconds when the Emergency button
is pressed. The low battery signal will be transmitted to the Control Panel. A supervisory
message will be sent during a low battery state.
FCC Statement
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not
cause harmful interference, and (2) This device must accept any interference received, including interference that may cause
undesired operation.
FCC Caution
To assure continued compliance, any changes or modifications not expressly approved by the party responsible for compliance
may void the user’s authority to operate his equipment. (Example – use only shielded interface cables when connecting to
computer or peripheral devices)
This device must not be co-located or operated in conjunction with any other antenna or transmitter.
FCC Radiation Exposure Statement
This equipment complies with FCC radiation exposure limits set forth an uncontrolled environment. This equipment should be
installed and operated with minimum distance of 20 cm between the radiator and your body.
FCC Section 15.105 Information to the user.
NOTE:
This equipment has been tested and found to comply with the limits for a lass B digital device, pursuant to Part 15 of the FCC
Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This
equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the
following measures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
-- Consult the dealer or an experienced radio/TV technician for help.