Parts List

Table Of Contents

FCC ID: XO8-FS917 rev. A01

Model#: FS917

Fall Sensor – FS917

This Fall Sensor is designed for a user to push the button for help at any time. It can also automatically

activate an emergency alarm

if it detects a fall in the event that the user is unable to trigger an alarm by pressing the button.

A. Usage Recommendation

1. For best results, the Fall Sensor should rest at the center of the user’s breastbone. Adjust the lanyard length using the sliding

clasp so that the device rests as the center of the user’s breastbone.

2. Wear the Fall Sensor on the outside of all articles of clothing.

3. Carefully place the Fall Sensor on a table or nightstand when you are not using it in order to avoid activating an alarm.

4. The Fall Sensor may be worn in the shower (IP45 rated).

B. Identifying the Parts

1. Emergency Button Pressing the Emergency Button for 0.5 sec will activate the Control Panel, causing it to dial an emergency call

or alarm (CID event code: 101).

2. LEDs

-LED Off =Standby Mode

- 1 Red Flash= Replacement Battery Inserted

- 1 Red, then 1 Green Flash =First button press after replacing battery

- 1 Green Flash= Transmitting with Good Battery

- 1 Red Flash= Transmitting with Low Battery

3. Lanyard

The lanyard length is adjustable by holding this piece and pulling the loop to increase or decrease the lanyard length.

4. Battery Compartment Cover

1. When replacing the battery, ensure that the positive side (+) of the battery is facing outward. 2. After replacing the battery, press

and hold the Emergency Button until you see the LED flash RED then GREEN.

C. Low Battery Detection and Supervision

Fall Sensor features Auto Low Battery detection and Supervision. When a battery is below the low battery threshold, the Fall Sensor

will automatically send a low battery supervisory message every two hours.

D. Testing

When testing, do not activate the Fall Sensor twice within a 10-second interval.

Note: Fall Sensors do not detect 100% of falls. If you are able to do so, you should always press the button if you need help.

PAGE 1
Model#: FS917 Fall Sensor – FS917 This Fall Sensor is designed for a user to push the button for help at any time. It can also automatically 1 activate an emergency alarm if it detects a fall in the event that the user is unable to trigger an alarm by pressing the button. A. Usage Recommendation 1. For best results, the Fall Sensor should rest at the center of the user’s breastbone. Adjust the lanyard length using the sliding clasp so that the device rests as the center of the user’s breastbone. 2.
PAGE 2
E. Battery & Electrical Specifications -Frequency: 917MHz-919MHz-921MHz -Battery: CR2477, 3V 1000mAh - Battery life: 2yrs with an average of one button push per day. - Open Field Range: Approximately 200 ft. FCC Statement This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation.