Installation Insert the lens and the four positioning posts on the camera body into the positioning holes, and tighten the two parts of the use case. Once the lens and body are installed, align them with the metal slots of the battery and press firmly to ensure that the battery clips completely catch the lens and body. MicroSD card slot cover installation Place the SD card with a gold-red side and place it in the SD card slot toward the side where the camera has no screen.
the side of the camera that has no screen, first aligning into the slot. Press firmly on the cover, and make sure that the yellow color at the button is no longer displayed, it is considered to be completely covered with a waterproof board. Please note that the button on the cover and the microphone hole on the bottom are in a vertical line for the correct orientation. If installed in the opposite direction, there may be a risk during exercise.
hardware currently used for making samples is not waterproof enough. Camera boot and SD card instructions Press and hold the camera's power button for 2 seconds, and the camera will perform power on/off. The boot animation will display the current firmware version number for confirmation. After the power is turned on, the lens screen appears, but if the blue light flashes, the available MicroSD card is not recognized.
* The camera needs to use a MicroSD card that supports the v30 standard. The file format of the card is exFat. The supplied sandisk v30 MicroSD is available. Switch shooting mode and resolution gear to shoot 1. In the upper left corner of the camera shooting preview interface, the displayed information is the number of photos that can be taken or the length of the video that can be taken under the current settings. The right side shows the current battery level.
2、Among them 1/ 2.3" lens support recording the following: mode Resolution Take a photo (support 4000x3000 Frame rate shooting dng photos Video HDR Video 1. 3840x2160 60 4000x3000 30 1920x1080 120 1920x1080 200 3840x1920 30 Use APP to connect, control shooting, read back albums, play content 2. 2. Please download the iOS app from the following address (currently only supports iOS) https://www.pgyer.com/vL3b 3. 3.
4. After the connection is successful, open the OneR APP, click the capture button, enter the shooting interface, set the parameters and shoot (the current version of the APP control camera shooting stability is not enough, it is recommended to use the camera screen to control the shooting). Once you have the content, you can click on the album entry to view the files on the camera's MicroSD card. Click to play or download any file.
perform the gyroscope calibration. During the calibration process, the camera indicator will flash alternately between blue and green. After the calibration is completed, the camera will automatically restart. Shooting precautions 1.
4. Use 1" lens to shoot night scenes. It is recommended to use 5.4K@30fps and raw photos. The picture quality of 4K@60 and 1080P@120 frames is not good enough. 5. If you used a 1/2.3" lens to take a photo with the manual exposure parameter, first switch the exposure mode to auto exposure, then switch to the recording mode to shoot. Avoid some bugs. 6, 1 / 2.3" lens 1080P@120fps gear position, the current settings exposure, white balance and other parameters will not take effect.
These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation.
This device complies with FCC’s radiation exposure limits set forth for an uncontrolled environment This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions : (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. 5.15-5.25GHz Band ÿOperations in the 5.15-5.25GH band are restricted to indoor use only.