Operation Instruction

ManualsBrandsINSIZE ManualsElectronicsWIRELESS DIFITAL CALIPER

Table Of Contents

2 2

54 6 7

9 10 11 12

OPERATION INSTRUCTION

MN-1113-E

Wireless Digital Caliper

1. Install battery:

Remove the battery cover ,put CR2032 battery into battery house, the positive side of

battery (+) should face out (fig.1), close the battery cover.

2. Buttons:

---'in/mm' is for inch and mm conversion

---'OFF/ON' is to turn on/off

---'ZERO' is to set zero

---Press the data transfer button to trigger data collection, and send one data each time

---For each successful data transmission, the red light flashes once

3. Please clean the measuring faces with soft cloth, then close the external jaws and press

'ZERO' button to set zero. Caliper should be checked regularly to make sure that it is

properly zero set.

4. To get accurate measurement, it is necessary to control the force. During measurement,

please always apply constant and proper force on the caliper. The measuring jaws should

"hold" the workpiece and can still "slide" on the workpiece.

7. One battery can last for one year use. When the battery is running out, the display will

become weak, abnormal reading or other phenomena will appear when moving the digital

unit, please remove battey. If caliper is not be used for more than 3 months, please

remove the battery. Otherwise, liquid may leak from the battery and damage the caliper.

6.Optional accessory:receiver(code 7315-2, 7315-3).Reference MN-7315R.Application as

follows:

8. If digits do not change when buttons are pressed, take out battery and put it back after 1

minute.

5. Automatic power off in about five minutes. Press 'OFF/ON' button or move the digital unit

to turn on display.

9. Working temperature is 0-40

C/32-104

F, relative humidity should not exceed 80%.

fig.1

Attention:This caliper is not waterproof. If the sticker contacts the coolant or other

reagents, it will cause incorrect or confused reading. Coolant or other

reagents cannot be removed by ethanol, WD40 can beused to remove .

1-Step measuring faces

2-Internal measuring jaws

3-Data transfer signal light

4-'mm/in' button

5-LCD display

6-Locking screw

7-Data transfer

8-External measuring jaws

9-'OFF/ON' button

10-'ZERO' button

11-Battery cover

12-Thumb roller

13-Depth measuring bar

Resolution: 0.01mm/0.0005"

Accuracy: ±0.03mm

Remove

CR2032

multichannel receiver (7315-2)

VIDEO

Summary of content (2 pages)

PAGE 1
OPERATION INSTRUCTION Wireless Digital Caliper Attention:This caliper is not waterproof. If the sticker contacts the coolant or other reagents, it will cause incorrect or confused reading. Coolant or other reagents cannot be removed by ethanol, WD40 can beused to remove . Resolution: 0.01mm/0.0005" Accuracy: ±0.03mm 2 V ID EO 2 3 4 5 6 7 2.
PAGE 2
OPERATION INSTRUCTION Wireless Digital Caliper 10. FCC statement: 1. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: ( 1) This device may not cause harmful interference. ( 2) This device must accept any interference received, including interference that may cause undesired operation. 2. Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.