Installation Guide

Mounting Adaptor (#11599-E)
Installation Instructions
1. Place mounting flange (1) up over
existing collar adaptor connection lip. It
may require a slight force fit.
2. Push mounting flange (1) up out of the
way and fit mounting gasket (2) onto the
sink bowl connection lip.
3. Move mounting flange (1) down over the
mounting gasket (2). Be certain that the
threaded fasteners in the mounting
flange (1) fit into recesses in the top of
the mounting gasket (2).
4. Attach two screws (3) through opposite
holes in the mounting gasket (2), and
into the threaded fasteners in the
mounting flange (1). The screws (3)
should be protruding approximately
1/4 inch below the mounting gasket (2).
5. Position the disposer beneath the
mounting gasket (1) and engage the two
protruding screws in the keyhole slots
in the disposer body flange. Assemble
the remaining four screws (3) and turn
the disposer into place for plumbing
connections. Tighten all screws evenly
to secure the unit.
This adaptor will fit a sink opening of: 6-5/8" I.D. and 7-1/8" O.D.
Part No. 13966-P October 2007
Sink Bowl
Connection Lip
Threaded Fasteners
(2) Mounting Gasket
(#11016)
(3) Screw
(#1491)
(1) Mounting Flange
(#11004)
Disposer
Body Flange
Keyholes
Sink