Installation Guide

Mounting Adaptor (#11599-A)
Installation Instructions
1. Place the split ring (2) around the sink
bowl connection neck (located just above
the sink bowl connection lip). Insert ten
screws (1) through the split ring (2), flat
gasket (3), and spacer sleeve (4). With
screws protruding through the spacer
sleeve (4), attach ten lock washers (5)
and ten nuts (6). Tighten all screws evenly.
2. Place mounting flange (7) over the
spacer sleeve connection lip (4). Push
mounting flange (7) up out of the way
and fit inside groove of the mounting
gasket (8) onto the spacer sleeve
connection lip (4).
3. Move mounting flange (7) down over
mounting gasket (8). Be certain that the
threaded fasteners in the mounting
flange (7) fit into recesses in the top of
the mounting gasket (8).
4. Attach two screws (9) through opposite
holes in the mounting gasket (8), and
into the threaded fasteners in the
mounting flange (7). The screws (9)
should be protruding approximately
1/4 inch below the mounting gasket (8).
5. Position the disposer beneath the
mounting gasket (8) and engage the
two protruding screws in the keyhole
slots in the disposer body flange.
Assemble the remaining four screws (9)
and turn the disposer into place for
plumbing connections. Tighten all screws
evenly to secure the unit.
13966-M REV A
(1) Screw
(#1491)
(3) Flat Gasket
(#12614)
(4) Spacer Sleeve
(#12664-A)
(5) Lock Washer
(#11444)
(6) Nut
(#11179)
(7) Mounting Flange
(#11004-C)
(8) Mounting Gasket
(#11341)
(9) Screw
(#1491)
(2) Split Ring
(#14720)
Disposer
Body Flange
Threaded Fasteners
Sink Bowl
Connection Lip
Adaptor Flange
Connection Lip
Keyholes
Sink
This adaptor will fit a sink opening of: 7" I.D. and 7-3/4" O.D.