Installation Guide

Mounting Adaptor (#11378-C)
1. Assemble the rubber sleeve (2) to the
throat of the sink bowl with one of the
clamping bands (1).
2. Insert the flange of the spacer sleeve (4)
into the groove of the mounting gasket (5).
3. Place the flat gasket (7), support ring (6),
spacer sleeve/mounting gasket assembly
on top of the disposer body flange. Slide
the mounting flange (3) over the spacer
sleeve (4) and onto the mounting
gasket (5). Be certain that the threaded
fasteners in the mounting flange (3) fit
into the recesses in the top of the
mounting gasket (5).
4. Fasten six screws (8) through holes in
disposer body flange, flat gasket (7),
support ring (6), mounting gasket (5),
and into the threaded fasteners in the
mounting flange (3). Tighten screws evenly.
5. Position the disposer under the rubber
sleeve (2). Extend the adjustable legs of
the disposer to provide support from
the floor.
NOTE: Disposers from 3 H.P. through
10 H.P. have factory assembled legs.
Disposers from 1/2 H.P. through 2 H.P.
require two accessory legs.
6. Turn the disposer into position for
plumbing connections. Slide the spacer
sleeve (4) into the bottom of the rubber
sleeve (2) and tighten with the other
clamping band (1). Adjust the support
legs for final positioning.
Installation Instructions
(SUPPORT LEGS ARE REQUIRED)
13966-AC REV A
Throat
Threaded Fasteners
(6) Support Ring
(#14724)
(4) Spacer Sleeve
(#11563)
(2) Rubber Sleeve
(#13120-D)
(3) Mounting Flange
(#11004-A)
(8) Screw
(#1491)
(1) Clamping Band
(#13119-C)
(1) Clamping Band
(#13119-C)
(5) Mounting Gasket
(#11342-A)
(7) Flat Gasket
(#11292)
Disposer
Body Flange
Keyholes
Sink
This adaptor will fit a sink opening of: 4-1/2" I.D. and NO FLANGE