Installation Guide

Mounting Adaptor (#11378-B)
Installation Instructions
(SUPPORT LEGS ARE REQUIRED)
1. Assemble the rubber sleeve (2) to the
throat of the sink bowl with one of the
clamping bands (1).
2. Insert the flange of the spacer sleeve (4)
into the groove of the mounting gasket (5).
3. Place the spacer sleeve (4) and
mounting gasket assembly on top of the
disposer body flange. Slide the mounting
flange (3) over the spacer sleeve (4) and
onto the mounting gasket (5). Be certain
that the threaded fasteners in the
mounting flange (3) fit into the recesses
in the top of the mounting gasket (5).
4. Fasten six screws (6) through holes
in disposer body flange, mounting
gasket (5), and into the threaded
fasteners in the mounting flange (3).
Tighten screws evenly.
5. Position the disposer under the rubber
sleeve (2). Extend the adjustable legs of
the disposer to provide support from
the floor.
NOTE: Disposers from 3 H.P. through
10 H.P. have factory assembled legs.
Disposers from 1/2 H.P. through 2 H.P.
require two accessory legs.
6. Turn the disposer into position for
plumbing connections. Slide the spacer
sleeve (4) into the bottom of the rubber
sleeve (2) and tighten with the other
clamping band (1). Adjust the support
legs for final positioning.
Part No. 13966-AB October 2007
This adaptor will fit a sink opening of: 7" I.D. and NO FLANGE
Throat
Threaded Fasteners
(4) Spacer Sleeve
(#11562)
(2) Rubber Sleeve
(#13120-B)
(3) Mounting Flange
(#11004-C)
(6) Screw
(#1491)
(1) Clamping Band
(#13119-A)
(1) Clamping Band
(#13119-A)
(5) Mounting Gasket
(#11341)
Disposer
Body Flange
Keyholes
Sink