Installation Guide

1. Place mounting flange (1) up over
existing sink bowl connection lip. It
may require a slight force fit.
2. Push mounting flange (1) up out of the
way and fit inside groove of mounting
gasket (2) onto the sink bowl
connection lip.
3. Move mounting flange (1) down over
mounting gasket (2). Be certain that
the threaded fasteners in the mounting
flange (1) fit into recesses in the top
of the mounting gasket (2).
4. Attach two screws (5) through
opposite holes in the flat gasket (4),
support ring (3), mounting gasket (2)
and into the threaded fasteners in the
mounting flange (1). The screws (5)
should be protruding approximately
1/4 inch below the flat gasket (4).
5. Position the disposer beneath the flat
gasket (4) and engage the two
protruding screws in the keyhole slots
in the disposer body flange. Assemble
the remaining four screws (5) and
turn the disposer into place for
plumbing connections. Tighten all
screws evenly to secure the unit.
Mounting Adaptor (#11327-C)
Installation Instructions
Sink Bowl
Connection Lip
Threaded Fasteners
(1) Mounting Flange
(#11004-D)
(3) Support Ring
(#14725)
(4) Flat Gasket
(#11292)
(5) Screw
(#1491)
(2) Mounting Gasket
(#11342-B)
Disposer
Body Flange
Keyholes
Sink
This adaptor will fit a sink opening of: 5-1/4" I.D. and 5-11/16" O.D.
13966-C REV A