User's Manual

ManualsBrandsInsideTNC ManualsElectronicsMagic Presenter Transmitter

●To make it your Presentation better, the new Magic Presenter integrates the function

of a laser pointing and slide Next/Previous/search. The Magic Presenter compact and

complete design gives you the easy control if presentation slide and mobility needed

concentrate on your presentation at a range of over 10m.

●Any software and PC programming is not required and a few second is taken of installation to use

-Slide Next/Previous/Search

-Plug and play function (No PC Programming and software)

-Working on any computers using a USB port

-Remote control range within 10m with a very low power

(Eliminates line-of-sight problems encountered with infrared systems)

-Transmitter identification (Use thousands of ID number to avoid multi-user interferences)

General Description

Key Features

Summary of content (6 pages)

PAGE 1
General Description ●To make it your Presentation better, the new Magic Presenter integrates the function of a laser pointing and slide Next/Previous/search. The Magic Presenter compact and complete design gives you the easy control if presentation slide and mobility needed concentrate on your presentation at a range of over 10m.
PAGE 2
Key Features Transmitter Radio Frequency Laser Module Interface Support OS Battery Operating Current Enclosure Dimension Weight Terms and Explanation Receiver 433Mhz(Europe), 311Mhz(Korea,USA) Wavelength : 670nm(Class llla) Output Power : 2.5+-0.5mW USB HID Spec., Ver.1.
PAGE 3
Transmitter Receiver General Description Laser Hole Receiver Indicator Search Previous Next Laser USB Connector Laser Button : Laser on/off control LED Indicator Next Button : Slide Next control Previews Button ; Slide Previous control Search Button(S) : Slide search control Blinking : Connected and waiting for ID Off : ID received and waiting for CMD Off-On-Off : Everytime CMD received
PAGE 4
1. When you plug a receiver into a USB port, You will see LED indicator is blinking.. 2. Push a either Next or Previews button USB Port USB Port Desktop or Notebook PC INFORMATION TO THE USER In the transmitter to implant user ID. When ID is set, LED goes to command waiting state. 3. Begin your presentation.
PAGE 5
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
PAGE 6
Any Changes or modifications not expressly approved by the manufacturer could void the user’s authority to operate the equipment. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operations.