InsideTNC IV012A USER’S GUIDE
Copyright© 2000 Inside Teletcom Co.,Ltd. This installation guide is copyrighted. All rights reserved. This document may not, in whole or part, be copied, reproduced, reduced or translated by any means, either mechanical or electronic, without prior consent in writing from Inside Telnetcom Co., Ltd. The information in this manual has been carefully checked and is believed to be accurate. However, Inside Telnetcom Co., Ltd assumes no responsibility for any inaccuracies that may be contained in this manual.
FCC RF INTERFERENCE STATEMENT NOTE : This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
- CONTENTS 1. Features of InsideTNC’s IV012A ……………………………………………… - The Feature of GeForce2 MX/GTS System Requirement Driver and Software Support 2. Installation (Hardware) ……………………………………………………………… 3. Installation (Software) ………………………………………………………………… Method I. Plug& Play ………………………………………………………………………… Method II. Do it your self …………………………………………………………………… 4. Troubleshooting ……………………………………………………………………… APPENDIX * Table 1-1. Windows 95/98ME Resolution rate & Refresh rate- 32MB * Table 1-2.
1. The Feature of InsideTNC’s IV011A Used nVIDIA’s GeForce2 MX/GTS GPU, Inside Telnetcom’s IV011A supports the advanced features, TwinView, a innovative dual display architecture, which doubles your desktop workspace using two space saving display and. DVC(Digital Vibrance Control) which provides crisp, bright visuals. IV011A(DREAM.
Driver and Software Supports - - Display Driver for Windows 95/98/ME Display Driver for Windows 2000, WindowsNT 4.0/3.5 OpenGL ICD for Windows 2000, Windows NT 4.0, Windows 95/98/ME Display Driver f for Linux, OS/2 Before Installation To avoid accidental electric chock, shut your computer down and unplug the power cord before staring the following procedures. Remember which cable go to which connectors. You may want to label your computer’s cable before disconnection them.
2. Installation (Hardware) 1. With the power off, remove your computer cover and locate on AGP slot. 2. Insert your card firmly into the slot. Card should be taken to press it evenly and snugly into its slot. Do not force! NOTICE. AGP slot is designed as a double structure in a different way from PCI slot. When DREAM.GRAPHICS is not inserted into its AGP slot snugly, your computer system can not work at all; therefore, you must set your board firmly into the slot.
3. Once you are certain that the card is installed properly in its slot, secure it to the PC frame with the screw you removed in step. Make sure the card does not lift out of the slot while tightening the bracket screw. Connect your monitor cable to the 15 pin-connectors on your computer. 4. Secure the cover and reboot your computer. Continue with the software installation for operating system in the following section.
3. Installation (Software) This section describes the software installation process for supported Windows. To install theGeForce2 MX driver 1. Start up Windows and log onto and account with administrator privileges. 2. Place the GeForce2 MX/GTS CDROM disk into your CD-ROM drive. When the installation window opens, choose the installation. 3. Follow the instructions that appear on your screen. 4. Restart your system at the prompt.