User's Guide
Table Of Contents
- INSEEGO COPYRIGHT STATEMENT
- INSEEGO TRADEMARKS AND SERVICE MARKS
- Contents
- Overview
- Description
- Indicator LEDs
- Installation Overview
- System Requirements
- Installing a SIM Card
- Installing the Battery
- Connecting Antennas
- Mounting Precautions and Guidelines
- Mounting the Device
- Powering the Device
- Connecting your Device
- Connecting to the Web UI
- Resetting your Router
- Getting Support
- Logging In
- Home Page
- Managing Bluetooth Sensors
- Managing Connected Devices
- Configuring GPS
- Managing Settings
- Accessing Messages
- Viewing Info About the Router
- Getting Help
- Overview
- Firewall
- MAC Filter
- LAN
- Port Filtering
- Port Forwarding
- IPPT
- Remote Management
- VPN
- Included Accessories
- Optional Accessories
- Power Cable
- USB Cable and Adapter
- Product Specifications
- Regulatory Information
- Wireless Communications
- Limited Warranty and Liability
- Safety Hazards
- Safety Hazards
- Installation and Operating Instructions
SKYUS100BSERIESUSERGUIDE
44
Qualityfactor:Specifiestheaccuracyofcalibrationneededpriortocompletionofthecalibration
process. NOTE: This is similar to a % confidence level for auto-calibration. If set to 75, then calibration
isconsideredcompletewhenthedevicecalculatesthatthereisa75%probabilitythatiscorrect.
Valuesbelow25%arenotallowedbecausetheresultswouldbeunreliable.Ahighernumberwill
enable a more accurate calibration, but it will take longer to complete the calibration process.
Mode: Choose between Motion detection and Driver behavior. The selections below will change
depending on your choice.
Motion Detection
Motiondetectiondetects,monitors,andreportsonlyforbulkmovementsthatwillshowthatthe
deviceismovingornot.ThismodeisgenerallyusedwhentheSkyusdeviceisinstalledinmachineryor
a vehicle that should not move, so as to cause an alert if motion is detected.
Threshold:TheGforcethattriggersamotionevent.CountandHoldtimesettingsareusedtoensure
the motion event is genuine.
Count: The number of consecutive samples above the Threshold (G force) needed to trigger a motion
event.Forexample,ifCountissetto100andthereare98consecutivesamplesabovetheThreshold
value,thenonesamplebelowthethreshold,thecountrestartsat0andnomotioneventistriggered.
NOTE:Thesamplingrateis10Hz(10samplespersecond).YoucanconverttheCountvaluetoatime
interval (in seconds) by dividing the Count value by 10.
Hold time: The delay, in seconds, before a motion event is cleared. The accelerometer waits for this
amount of time to determine if the event is finished. If additional readings above the Threshold value
arereceivedduringtheHoldtimeinterval,theyareconsideredpartofthesameeventandtheHold
timetimerisrestarted.WhennoadditionalreadingsabovetheThresholdvaluearereceivedfora
period equal to the Hold time, the event is considered finished.
Click Save Changes.
Driver Behavior Detection
Driverbehaviordetectsandmonitorsmotion,direction,rates,andaccelerationstoprovide
information related to driver behavior. This mode is used when the Skyus device is installed in a
vehicle and you wish to monitor vehicle operation.