User's Guide
Table Of Contents
- INSEEGO COPYRIGHT STATEMENT
- INSEEGO TRADEMARKS AND SERVICE MARKS
- Contents
- Overview
- Description
- Indicator LEDs
- Installation Overview
- System Requirements
- Installing a SIM Card
- Installing the Battery
- Connecting Antennas
- Mounting Precautions and Guidelines
- Mounting the Device
- Powering the Device
- Connecting your Device
- Connecting to the Web UI
- Resetting your Router
- Getting Support
- Logging In
- Home Page
- Managing Bluetooth Sensors
- Managing Connected Devices
- Configuring GPS
- Managing Settings
- Accessing Messages
- Viewing Info About the Router
- Getting Help
- Overview
- Firewall
- MAC Filter
- LAN
- Port Filtering
- Port Forwarding
- IPPT
- Remote Management
- VPN
- Included Accessories
- Optional Accessories
- Power Cable
- USB Cable and Adapter
- Product Specifications
- Regulatory Information
- Wireless Communications
- Limited Warranty and Liability
- Safety Hazards
- Safety Hazards
- Installation and Operating Instructions
SKYUS100BSERIESUSERGUIDE
43
Accelerometer SubTab
Use this page to enable and configure accelerometer settings. Accelerometer settings are typically
used in mobile (automotive) environments.
General
Check the Enable Accelerometer box to turn on the accelerometer.
NOTE: The following settings apply regardless of the mode selected (Motion detection or Driver
behavior).
G Range: Specify thegravity(G)forcerange.Thisis themaximumvaluethatcanbe recorded
accurately. The wider the range, the less accurate the readings will be. The default value is 2g, which is
sufficient for normal vehicles. A value above 2g indicates a crash.
Check the Auto-calibration box to enable auto-calibration. NOTE: It is recommended to always check
this box if the accelerometer is going to be used.
Retain calibration data on restart: When this box is checked, the device automatically re-calibrates
on restart. Use this feature if the Skyus device is in a fixed location in a vehicle. In that case, it will allow
the accelerometer to perform auto-calibration faster. In other settings it should remain turned off.