Installation Instructions

ManualsBrandsInovonics Wireless ManualsElectronicsANALOG VOICE BASE STATION

QSR Performance Solutions Drive Thru System - Operating Instructions

Batteries and Battery Charger

• Be sure batteries are charged

• Batteries take 2 to 3 hours to charge

• A charge battery will last 8 to 10 hours

• When the battery voltage becomes too low, a short warble tone, occurring at five–second intervals is heard in the

headset. After 2 minutes the headset will shut off.

• Batteries only fit into charge one way, the correct way

• Charging indicator on charger will light red while battery is charging

• Charging indicator on charger will change from red to green when battery is fully charge

• Batteries should be left in charger even after they are fully charged

• Batteries should be removed from belt-pack and stored in charger when belt-pack is not being used

• Batteries not being used should stored in the charger

Charging Indicators

Charging Ports for

Batteries

Battery Charger

Installing and Removing Batteries from Belt-Pack

• Insert battery into battery compartment on belt-pack so it locks into place

• Battery will only fully insert into battery compartment the correct way

• To remove battery, slide battery release away from battery

Battery

Compartment

Battery

Release

Summary of content (4 pages)

PAGE 1
QSR Performance Solutions Drive Thru System - Operating Instructions Batteries and Battery Charger • • • • • • • • • • Be sure batteries are charged Batteries take 2 to 3 hours to charge A charge battery will last 8 to 10 hours When the battery voltage becomes too low, a short warble tone, occurring at five–second intervals is heard in the headset. After 2 minutes the headset will shut off.
PAGE 2
QSR Performance Solutions Drive Thru System - Operating Instructions Programming the Belt-Packs • • • • • • • • Belt-packs must me programmed to the base station before they will operate properly Programming station should already be plugged into base station Make sure power indicator on base station is lit Insert battery in belt-pack Make sure belt-pack power is turned OFF Insert belt-pack into programming station Turn belt-pack power ON Power indicator on belt-pack will flash green during programming (ab
PAGE 3
QSR Performance Solutions Drive Thru System - Operating Instructions Taking Orders • • • • • • • Belt-pack should be in pouch and clipped to belt or waist-band on pants Headset cable should be clipped near waist and near collar Headset should be worn on head The headband is adjustable Make sure power indicator on belt-pack is lit green When a car arrives at the menu-board, fast double beep will be heard every 3 seconds Press the talk button on the belt-pack to talk to the customer For information on all o
PAGE 4
QSR Performance Solutions Drive Thru - Belt-Pack 1 2 3 4 5 6 7 8 9 10 11 Bottom View 1. Page Press to talk to the other headsets without being heard at the speaker post • Belt-packs can be programmed for Page Monitor Mode, they will only hear communication from other belt-packs that are using the Page button and will not hear communication to or from the speaker post • To program a belt-pack for Page Monitor Mode, hold Page button down while powering the headset on.