Innr ZigBee Module, US variant Innr ZB Mod v1.
Edition Completion Date Revision record Author V1.0 2016-07-20 establish kui V1.
catalogue 1 summary ......................................................................................................................................................... 1 2 characteristic ................................................................................................................................................... 1 2.1 Interface ........................................................................................................................................ 1 2.
1 summary Innr ZB Mod v1.1 US is a ZigBee 3.0 reference design module based on embedded chip (JN5169). Stamp hole interface, PCB on-board antenna, small size, easy to develop, rich interface. The module is suitable for intelligent household appliances, smart home, intelligent toys, industrial control of things applications.
2.3 else 2 UARTs: one capable of hardware flow control (4-wire, includes RTS/CTS); the other just 2-wire (RX/TX) Master SPI-bus port with 3 select outputs Slave SPI-bus port 1 programmable timer/counter which supports Pulse Width Modulation (PWM) and capture/compare, plus 4 PWM timers which support PWM and Timer modes only 3 Size of product Table 3 / 1 list of product specifications Heading Support for ZigBee 3.0 Radio frequency system Parameter number 2.4 GHz IEEE802.15.
interface type 、SPI、GPIO、PWM、I²C、I²S UART 2Mbps@UART (Max) interface rate 50Mbps@SPI (Max) Hardware part – 3.6V working voltage 2.0V working current 10mA working humidity Storage temperature working temperature outline dimension – 25mA （No condensation） -40~+125 ℃ -40~+85℃ 14.7mm×22.
Fig. 4 / 1 module pin arrangement and size diagram The module pin instructions are shown in Table 4 / 1: Table 4 /1 Module Pin Description.
16 GND 17 I/O V SS DO1 V SS — ground DO1 — DO1 SPIMISO — SPI-bus Master In, Slave Out input PWM3 — PWM3 output 18 I/O DIO18/SPIMOSI DIO18 — DIO18 SPIMOSI — SPI-bus Master Out Slave In output DIO19 — DIO19 SPISEL0 — SPI-bus master Select Output 0 19 I/O DIO19/SPISEL0 20 O DO0/SPICLK/PWM 2 21 P/I I VREF/ADC2 ADC1 DO0 — DO0 SPICLK — SPI-bus master clock output PWM2 — PWM2 output VREF — analog peripheral reference voltage ADC2 — ADC input 2 ADC1 — ADC input 22 I 23 DIO0/ADO/SPISEL 1/ADC3 2
4,FCC ID warnings: This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. This device complies with part 15 of the FCC Rules.
