Wireless Internet of Things System 无线物联网系统 TYPE：WIOT
法律声明 Legal Notices 责任声明 Statement of liability 在适用法律允许的范围内，在任何情况下，本公司都不对因本文档中相关内容 及描述的产品而产生任何特殊的、附随的、间接的、继发性的损害进行赔偿，也 不对任何利润、数据、商誉、文档丢失的损失进行赔偿。 To the extent permitted by applicable law, under no circumstances shall the Company compensate for any special, ancillaally, indirect, secondary damages arising from the products related to and described in this document, nor shall it compensate for any loss of profits, data, goodwill or documents.
关于本文档 About this document 本文档供WIOT产品使用，产品外观和功能请以实物为准。 This document is intended for use by WIOT products, subject to physical appearance and functionality. 如果不按照本文档中的指导进行操作而造成的任何损失由使用方自己承担。 Any loss resulting from failure to follow the instructions in this document is borne by the user.
使用要求 Requirements 请勿将设备放置和安装在阳光直射的地方或发热设备附近。 Do not place and install the device in direct sunlight or near the heating device. 请勿将设备安装在潮湿、有灰尘或煤烟的场所。 Do not install the device in a damp, dusty or soot area. 请保持设备的水平安装，或将设备安装在稳定场所，注意防止本产品坠落。 Keep the device installed horizontally or in a stable place, taking care to prevent the appliance from falling.
operation, please regularly use a brush to the circuit board, plug-in, chassis, etc. to dust. 请保证设备水平固定安装，确保内部抗震部件正常工作。 Make sure that the equipment is installed at a fixed level to ensure that the internal seismic parts are working properly.
目录 table of Contents 法律声明............................................................................................................................ 1 Legal Notices ................................................................................................................... 1 使用安全须知 .................................................................................................................... 2 Safety instructions ..................................................................................
1.2.1 Front panel ........................................................................................... 10 1.2.2 后面板 ..................................................................................................... 11 1.2.2 Rear panel ............................................................................................. 11 1.3 设备安装 ............................................................................................................ 12 1.3 Device installation .........................
无线物联网系统烟雾传感器 Wireless Internet of Things System Smoke sensor 无线物联网系统门磁传感器 Wireless Internet of Things System Magnetic sensor 无线物联网系统声光报警器 Wireless Internet of Things System Audible alarm 无线物联网系统摄像机 Wireless Internet of Things System IPC 一、 无线物联网系统主机 一、Wireless Internet of Things System host 1.1 产品概述 1.
产品图示 Product icon 电气性能及参数： Electrical performance and parameters: 1，设备工作温度：-20 ~85 摄氏度 Operating temperature: -20 to 85 degrees Celsius 2，设备存储温度：-25~105 摄氏度 Equipment storage temperature: -25 to 105 degrees Celsius 3，电源输入接口电压值：DC9V--36V， Power input voltage value: DC9V-36V 4，电源防反接最大保护电压：-DC36V Power supply anti-reverse maximum protection voltage: -DC36V 5，ACC 接口电压值：DC9V--36V ACC:DC9V-36V 6，IO 端口检测电压值范围：6 路输入，检测电压值 DC9-36V IO port detection voltage value range: 6 inputs, detection voltage value DC9-36V 7，CAN
15，小无线 433 功能：支持 small wireless 433 function: support 16，定位功能：支持 GPS+北斗双模式 positioning function: support GPS + Beidou dual mode 17，USB 接口：1 路 USB3.0 USB interface: 1 way USB3.0 18，防盗功能：供电，油泵断开控制功能。 Anti-theft function: power supply, oil pump disconnect control function. 19，远程升级功能：支持 Remote upgrade features: Support 20，复位功能：支持硬件复位操作。 Reset function: Supports hardware reset operations.
1.2 设备结构 1.2 Equipment structure 介绍设备的结构，包括前面板和后面板的指示灯，接口功能。 Describes the structure of the device, including the front and rear panel indicators, interface functions. 1.2.1 前面板 1.2.1 Front panel 介绍前面板的指示灯，接口功能。 This section describes the indicators on the front panel and the interface functions. 图示.前面板 Illustration. front panel 说明： Description： 1. 设备正常运行时，指示灯为绿色 The light is green when the device is up and running 2.
1.2.2 后面板 1.2.2 Rear panel 介绍后面板的接口功能。 Beschreibt die Schnittstellenfunktionen der Rückwand. 说明： Description： 1.RESET 设备恢复出厂设置 RESET device factory reset 2.IPC 接口， IPC interface, 3.
1.3 设备安装 1.3 Device installation 1.3.1 安装注意事项 1.3.1 Installation Precautions 安装基本要求 Basic requirements for installation 所有的电气工作都必须遵守使用地最新的电气法规、防火法规及有关的法规。 All electrical work must comply with the latest electrical regulations, fire prevention regulations and related regulations at the place of use. 安装时请务必关闭所有相关设备电源。 Always turn off all relevant devices when installing.
注意：拆装、接线等操作时请务必断开电源，切勿带电操作。 Note: Please be sure to disconnect the power supply when disassembling, wiring, etc. 环境要求 Environmental requirements 设备安装前，需要先进行安装位置和线路的部署侦察、规划，以确保电源和线路 安全稳定，同时需考虑布线的方便性和合理性。 Before the installation of equipment, the installation location and line deployment reconnaissance, planning to ensure the security and stability of power and line, at the same time need to consider the ease of wiring and reasonable.
Fixing: It is recommended to secure it using national standard M4 combination screws. All fixing screws must be fastened in place to avoid looseness after long driving bumps, resulting in equipment falling. 1.3.3、无线物联网系统主机固定方向 1.3.
FCC WARNING This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.
