Rhein Tech Laboratories, Inc. 360 Herndon Parkway Suite 1400 Herndon, VA 20170 http://www.rheintech.com Appendix I: Client: Model #: Standards: FCC ID: Report #: Innovative Wireless Technologies, Inc. IXU1-ASY1168 FCC 15.247 SP8-IXU1-ASY1168 2006098 Manual Please refer to the following pages.
mProm™ 900MHz Module USER MANUAL © 2006 Copyright Innovative Wireless Technologies P1b
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: 1. this device may not cause harmful interference, and 2. this device must accept any interference received, including interference that may cause undesired operation. FCC ID: SP8-IXU1-ASY1168 IMPORTANT NOTE: To comply with FCC RF exposure compliance requirements, the antenna used for this transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.
mProm™ 900MHz Mesh Networking Module User Manual Overview IWT’s mProm™ Module is a 900 MHz ISM transceiver module that offers an embedded microprocessor. The mProm module is designed for easy integration into systems needing connectivity or wire replacement. The mProm™ module utilizes the 902928MHz ISM band and is FCC certified for most integrated applications.
FCC Statement for OEM Integrators mProm™ Module Use for maintaining RF exposure This device is intended only for OEM integrators under the following conditions: 1. Connection to the mProm™ Module should always be made through the 26 pin header. Connection to the mProm™ Module any other way not expressed in this documentation or approved by Innovative Wireless Technologies, Inc. will void the user’s ability to operate this device under the FCC certification.
The mProm™ Module Interface (Getting Started) Voltage must be supplied to the mProm™ Module via pins 19 and 20 on the interface header. The mProm™ Module regulates its voltage on board, but must be supplied a voltage between 3.5-14 Volts. The table below outlines the 26 pin interface to the mProm™ Module. The mechanical diagram that follows indicates where pin-1 starts. Pin # 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 Pin Name CNVss BUSY/UART_CS GDO2_CC1100 3.
becomes inoperable, momentarily pulling pin 11 (RESET) low, 0-Volts, will reset the mProm™ Module.
mProm™ Module Electrical Specifications Parameter Min. Typ. Overall Max. Unit -40 902 3.5 Transmitter 38.4 85 928 14 ºC MHz V 500 kbps 10 dBm Delivered into 50 load dBm PER=1%, Measured through 50 load, conducted. Operation Temperature RF Frequency Range Absolute Supply Voltage Transmit Bit Rate Nominal Output Power 8 Receiver Receiver Sensitivity -100 General I/O Available GPIO SCHMITT-Trigger Input Specifications VIT+ Positive-going input threshold 0.
Mechanical Board Dimensions Figure 2 Module Dimensions (mils) © 2006 Copyright Innovative Wireless Technologies R1
Innovative Wireless Technologies 1047 Vista Park Drive Suite A Forest VA 24551 434-316-5230 © 2006 Copyright Innovative Wireless Technologies R1
