Rhein Tech Laboratories 360 Herndon Parkway, Ste 1400 Herndon, VA 20170 http://www.rheintech.com Client: Model: FCC ID: Standard: IWT AXONTM Module SP8-IWTBB1142 FCC 15.247 APPENDIX I: MANUAL Please refer to the following pages.
AXON™ USER MANUAL © Copyright 2005 Innovative Wireless Technologies P1b
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: 1. this device may not cause harmful interference, and 2. this device must accept any interference received, including interference that may cause undesired operation. FCC ID: SP8-IWTBB1142 IMPORTANT NOTE: To comply with FCC RF exposure compliance requirements, the antenna used for this transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.
Axon™ Innovative Wireless Technologies User Manual 802.15.4 Transceiver Module Overview IWT’s Module is a 2.4 GHz transceiver module that offers an embedded 16-bit RISC CPU and is designed to comply with IEEE’s 802.15.4 physical layer specifications. The module offers the user a compact size, ruggedized connections, and an on-board antenna.
FCC Statement for OEM Integrators AXON™ Module Use for maintaining RF exposure This device is intended only for OEM integrators under the following conditions: 1. Connection to the AXON™ Module should always be made through the 20 pin header. Connection to the AXON™ Module any other way not expressed in this documentation or approved by Innovative Wireless Technologies, Inc. will void the user’s ability to operate this device under the FCC certification.
The AXON™ Module Interface (Getting Started) Voltage must be supplied to the AXON™ Module via pins 19 and 20 on the interface header. The AXON™ Module regulates its voltage on board, but must be supplied a voltage between 3.3-6 Volts. The table below outlines the 20 pin interface to the AXON™ Module. The mechanical diagram that follows indicates where pin-1 starts.
AXON™ Module Electrical Specifications Parameter Min. Operation Temperature -40 RF Frequency Range Absolute Supply Voltage Transmit Bit Rate Transmit Chip Rate Nominal Output Power 2400 3.3 Transmitter 250 2000 Max. Unit 85 ºC 2483.5 +6 MHz V 250 2000 kbps kChips/s 0 Receiver Receiver Sensitivity -90 Dynamic Range Frequency Error Tolerance Typ. Overall dBm -94 90 -300 General I/O Available dBm 300 GPIO3-5 SCHMITT-Trigger Input Specifications VIT+ Positive-going input threshold 1.5 1.
Mechanical Board Dimensions Figure 2 Module Dimensions (mils) © Copyright 2005 Innovative Wireless Technologies P1b
Innovative Wireless Technologies 1047 Vista Park Drive Suite A Forest VA 24551 434-316-5230 © Copyright 2005 Innovative Wireless Technologies P1b
