Instruction Manual

Connect the plug to your AC 100-240V~5 Hz outlet
English Instruction Manual
1
PRE PAR ATION FOR USE
UNPACKING AND SET UP
Carefully remove the unit from the display carton
and remove all packing material from the unit.
Unwind the AC power cord and extend it to its full
length.
Place the unit on a stable level surface, which is
convenient to an AC outlet out of a strong
magnetic field.
Raise the lid to expose the phonograph. The
phonograph has been secured for shipment with
a transit screw. Use a coin or screwdriver to turn
the transit screw clockwise. This will allow the
turntable to “float”
Remove the opaque white plastic stylus cover
from the phonograph stylus by sliding it in the
direction of the arrow.
During this operation pay attention to the stylus,
because the stylus damage is not covered by
guarantee.
Remove the twist-tie that was used to secure the
tone arm during shipment.
Release the tone arm lock lever.
Unit Leg or Feet Assembly
1. Take out the unit and the legs, put them on a smooth surface.
2. Loosen the screws under the unit.
3. Insert the wooden leg into the hole and fix it with the screws
well.
4. Repeat to fix all of the 4pcs legs.
OR
If you want to place the unit on a shelf:
1. Remove the leg fixings from the bottom side and use instead
the short feet.
2. Repeat to fix all of the 4pcs feet.
2.按原孔位装上木腿,将用
拆下的螺丝固定即可。
1.
0-60