User Manual

Table Of Contents

1. Connect one end of supplied 6.35mm to 6.35mm plug audio cable into AF

OUT jack on rear panel of the receiver. Connect the other end of the audio

cable into "MIC IN" or "AUX IN" of amplifier or mixer.

2. Connect DC plug of supplied AC/DC adapter to DC INPUT jack on rear panel

of the receiver. Connect AC plug of AC/DC adapter to mains power socket.

3. Press ON/OFF button on front panel to turn on the receiver.

4. Turn on the transmitter. RF indicator on receiver will light.

5. Adjust receiver volume and your amplifier or mixer volume to suitable level.

5. Antenna

6. Mixed 1/4" unbalanced output jack

7. DC input jack

Frequency Range

Frequency Stability: ≤ 0.005%

Sensitivity: -100dBm

Mirror Image Rejection: ≥45 dB

S/N: ≥95dB

Distortion: ≤0.5%

Audio Output Level: ≤1V(10K)

Power Supply: DC12V/200MA

6 7

Front Rear

Specifications

Operation

UHF-01 WIRELESS RECEIVER

Parts Description

1. Power Indicator

2. ON/OFF Switch

RF Indicator3.

4. Volume Control

517.6MHz or 521.5MHz or 533.7MHz or 537.2MHz

PAGE 1
UHF-01 WIRELESS RECEIVER Parts Description Front 1 2 Rear 3 1. Power Indicator 2. ON/OFF Switch 3. RF Indicator 4. Volume Control 4 5 6 7 5. Antenna 6. Mixed 1/4" unbalanced output jack 7. DC input jack Operation 1. Connect one end of supplied 6.35mm to 6.35mm plug audio cable into AF OUT jack on rear panel of the receiver. Connect the other end of the audio cable into "MIC IN" or "AUX IN" of amplifier or mixer. 2.
PAGE 2
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.