Safety Instructions

ManualsBrandsINNOVATION&PERFECT ENTERPRISES ManualsCamera & PhotoLED SENSOR LIGHT WITH CAMERA



1



MotionActivatedDualHead

SecurityLightwithCamera

Model:PAC018,PAC027

Pleasereadallinstructionsthoroughlyandcarefullypriortoinstallingthisproduct.Retaintheseinstructionsforfuture

reference.



Weassumesnoliabilityorresponsibilityforclaimsarisingfromimproperinstallationorimproperuse.Failuretofollowthese

instructionscouldresultinvoidingtheproductwarranty.

IMPORTANTSAFETYINSTRUCTIONS

Beforeyoubegininstalling,servicing,ormaintenanceofthisproduct,followthesegeneralprecautions.

 Toreducetheriskofdeath,personalinjuryorpropertydamagefromfire,electricshock,fallingparts,cuts/abrasions

andotherhazardspleasereadallwarningsandinstructionsincludedwithandonthisproductpriortoinstallation.

 Forcommercialinstallation:serviceandmaintenanceofthisproductshouldbeperformedbyaqualified,licensed

electrician.

 Forresidentialinstallation:Ifyouareunsureabouttheinstallationormaintenanceofthisproduct,consulta

qualifiedlicensedelectrician.

 Donotmounttheunitagainstflammablesurfaces.

 Thisproductisintendedtobeusedoutdoors,andbesubjecttotheelements;suchasrainandsnowandwe

recommendittobemountedatleast6’6”offtheground

 ThisLEDproductmustbepowereddirectlytoaswitchedcircuit.

 Makesurethatwherethisfixturewillbemountedisstructurallysoundandthatitwillsupporttheweightofthis

fixture

 Thisproductshouldnotbeusedinareaswithlimitedventilationorhighambienttemperatures.

 ThisproductisintendedtobeconnectedtoaproperlyinstalledandgroundedULlistedjunctionbox.

WARNING:RISKOFELECTRICALSHOCK

 Turnoffelectricalpoweratfuseorcircuitbreakerboxbeforewiringproducttothepowersupply.

 Verifyvoltageis100V‐240Vbeforeinstalling.

 MakeallelectricalandgroundedconnectionsinaccordancewiththeNationalElectricCodeandanyapplicablelocal

coderequirements.

 AllwiringconnectionsshouldbecappedwithULlistedwireconnectors.

CAUTION:RISKOFPRODUCTDAMAGE

 Neverconnectfixturewithpoweron.

 Donotmountorsupportproductinamannerthatcancuttheouterwirejacketordamagethewireinsulation.

 AvoidcoveringLEDproductswithinsulation,foam,orothermaterialsthatwillpreventconvectionorconduction

cooling.

 NeverconnectanLEDproductdirectlytodimmerpacks,occupancysensors,timingdevices,orotherrelatedcontrol

devices,unlessindividualproductspecificationsdeemotherwis

e.

 LEDproductsarepolaritysensitive,ensureproperpolaritybeforeinstallation.

 ElectrostaticDischarge(ESD)cancausedamagetoLEDproducts.Wearpersonalgroundingequipmentduring

installationandserviceoftheproduct.

Summary of content (7 pages)

PAGE 1
Motion Activated Dual Head Security Light with Camera Model: PAC018 , PAC027 Please read all instructions thoroughly and carefully prior to installing this product. Retain these instructions for future reference. We assumes no liability or responsibility for claims arising from improper installation or improper use. Failure to follow these instructions could result in voiding the product warranty.
PAGE 2
 Do not touch the individual electronic components, it may cause ESD (Electronic Discharge), shorten lamp life or alter performance. CAUTION: RISK OF INJURY     Wear gloves and safety glasses at all times when removing fixture from carton, installing or servicing the product. Avoid direct eye exposure to the light source while it is on. LED LIGHTS ARE EXTREMELY BRIGHT, UNDER NO CIRCUMSTANCES SHOULD YOU LOOK DIRECTLY INTO AN LED LIGHT, THIS MAY CAUSE IRREPARABLE DAMAGE TO THE EYES.
PAGE 3
MOUNTING AND WIRING THE LIGHT Existing electrical wires from mounting surface NOTE: DO NOT MOUNT ON THE GROUND, RECOMMENDED INSTALLATION sHEIGHT IS 6 ½ FEET TO 10 FEET ** Before you begin make sure that your power is turned off at your circuit breaker box ** ** Do not rely on the switch power being turned off **** 3
PAGE 4
ADJUSTING YOUR LIGHT HEADS Your light heads can be adjusted by turning the individual light head to desired position. You can also adjust your light head up and down to your desired position. Indicator light: Note: Fixture can be wall mounted or eave mounted.
PAGE 5
Wall mounted Eave mounte\ (Light fixture and sensor should be mounted as shown above when installed (depending upon type of installation). APP User guide: Setting light through mobile device.Search”Guard 720”or “Swann security “in IOS APP store or in Android Google play.Install the”Guard 720” or” Swann security “App onto the device.(Take Guard 720 as an example) 1. * Register a new account: 2.
PAGE 6
3. TROUBLE SHOOTING If the light does not come on:  Verify the power is turned on at the switch and breaker  Verify that the product is properly wired  Verify that the line voltage is correct (100V‐240V) If the manual override stays on after dawn  The ambient light lever may be too low (not enough light) FCC WARNING Any Changes expressly or modifications not approved by the party responsible for compliance could void the user's authority to operate the equipment.
PAGE 7
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.