BT4.
Introduction This document describes Key feature, pin definition, mechanical drawing, Recommendation for PCB Layout and operation temperature and voltage range, and reflow data of Bluetooth Low Energy Module and it can helps designer to design in easier and manufacturing smoothly. BLE module Install Guide line Key Features RF • 2.
• Ultra-low-power analog comparator • UART • 2x SPI • Ultra-low power • I2C, I2S • Real-time clock • AES-128 security module • Support for 8 capacitive sensing channels Application Profile • Consumer electronics • Mobile phone accessories • Sports & Fitness equipment • HID applications • Home and Building Automation • Lighting Control • Alarm and Security • Electronic Shelf Labeling • Proximity Tags • Medical • Remote Controls • Wireless Sensor Networks
Mechanical Drawing
Module Pin Definition Bluetooth Module Pin # Pin Name 1 GND 2 Direction Voltage Description Power GND Ground DIO_0 Digital I/O 1.8V to 3.8V GPIO, ULP Sensor Interface 3 DIO_1 Digital I/O 1.8V to 3.8V GPIO, ULP Sensor Interface 4 DIO_2 Digital I/O 1.8V to 3.8V GPIO, ULP Sensor Interface 5 DIO_3 Digital I/O 1.8V to 3.8V GPIO, ULP Sensor Interface 6 DIO_4 Digital I/O 1.8V to 3.8V GPIO, ULP Sensor Interface 7 DIO_5 Digital I/O 1.8V to 3.
33 DIO_24 Digital/Analog I/O 1.8V to 3.8V GPIO, ULP Sensor Interface, Analog 34 DIO_25 Digital/Analog I/O 1.8V to 3.8V GPIO, ULP Sensor Interface, Analog 35 DIO_26 Digital/Analog I/O 1.8V to 3.8V GPIO, ULP Sensor Interface, Analog 36 DIO_27 Digital/Analog I/O 1.8V to 3.8V GPIO, ULP Sensor Interface, Analog 37 DIO_28 Digital/Analog I/O 1.8V to 3.8V GPIO, ULP Sensor Interface, Analog 38 DIO_29 Digital/Analog I/O 1.8V to 3.
Recommended: Operating Range over operating free-air temperature range (unless otherwise noted) MIN NOM MAX Operating ambient temperature range, TA Operating supply voltage –40 1.8 Recommendation: PCB Layout for User design UNIT 85 °C 3.
Reflow data
Federal Communication Commission Interference Statement This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
Radiation Exposure Statement: The product comply with the FCC portable RF exposure limit set forth for an uncontrolled environment and are safe for intended operation as described in this manual. The further RF exposure reduction can be achieved if the product can be kept as far as possible from the user body or set the device to lower output power if such function is available.
