Outdoor Remote Control Timer Switch [Instruction Manual] Thank you for your purchase. Please contact us if you have any questions. We will get back to you within 24 hours. Please attach your Order ID so that we can serve you better.
Warning: To reduce the risk of fire, electric shock or personal injury, please strictly follow the instructions. 1. To prevent water immersion, the outlet must be mounted in a vertical position with the outlets facing downward and at least 2ft above the ground level. 2. Do not immerse in water. 3. Do not connect any devices which may exceed the maximum ratings of this remote outlet. 4. Do not disassemble or repair the product, but only by authorized service personnel. 5.
Installation Guiding 1. Plug the receiver into a powered outlet,Plug your device into the socket of the receiver. 2. Install 3*AA 4.5V batteries for the transmitter. 3. Test if your device is paired: see if the receiver will turn ON/OFF by pressing the transmitter's ON/OFF button. NOTE: The transmitter and receiver have been paired in advance and can be used directly.
Transmitter Timing Settings Notes: The receiver must be located within 100 feet of the remote transmitter. Actual functional range may be affected by the following factors: weather, radio frequency interference, low remote battery, and obstructions between the transmitter and receiver. 1. Transmitter test Before setting the transmitter, place the transmitter at the location you want, and then press the ON/OFF button to test if the transmitter could successfully control the receiver. 2.
. P1/P2/P3 Mode a. Press and hold the P1 button for 3s until the number on the screen flashes to enter the ON time setting interface in the P1 mode. b. Press the hour/min button to set the ON time in P1 mode. c. Press the P1 button again to enter the OFF time setting in the P1 mode. d. Press the hour/min button to set the OFF time in P1 mode. e. Press the clock button to complete the setting of P1 mode and return to the current time interface. f.
d. Press the hour/min button to set the OFF time. e. Press the REP button to enter the REP mode start time setting, as shown in Figure 6-3. f. Press the hour/min button to set the start time g. Press the REP button to enter the setting of the end time, as shown in Figure 6-4. h. Press the hour/min button to set the end time. i. Press the clock button to complete the REP mode setting and return to the current time interface. j. After setting the REP mode, Press the REP button shortly to start the REP mode.
-1. CTD mode operation status: When the CTD mode and the P1/P2/P3 mode are running at the same time, the P1/P2/P3 mode will continue to run after the CTD mode ends, as shown in Figure 7-2 (during operation) and 7-3 (after the end). When only the CTD mode is running, keep always OFF after the CTD mode ends, as shown in Figure 7-4 (during running) and 7-5 (after finishing). 8. DST Mode DST: Daylight Saving Time a.
FCC STATEMENT This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions: 1) this device may not cause harmful interference, and 2) this device must accept any interference received, including interference that may cause undesired operation. Changes or modifications not expressly approved by the party responsible for compliance could void your authority to operate the equipment.