User Manual

ManualsBrandsINNCOM International ManualsElectronicsSwitch

EVORA Series Datasheet

Overview

The EVORA family of switches offers an elegantly designed, easy to use,

feature-rich user interface and control system providing a state-of-the-art

guestroom automation experience. EVORA allows guest control of multiple

lighting loads, temperature, drapes, and guest annunciation from multiple

switch locations in the guestroom. EVORA offers three different user interface

modules and multiple different Load Assemblies that include wired and

wireless communications, dimmers, and programmable controls designed to

operate within INNCOM’s Integrated Room Automation System (IRAS). The

EVORA system brings all guestroom control features into a sleekly designed

traditional keypad user interface.

Features

• Up to 7 key configurations with up to 5 position key pad for programmable control of any IRAS feature

• Nightlight configuration with 2 key positions

• Doorbell configuration with 2 key positions

• Optional multifunction key for up to 10 grouped features per device

• Backlight illuminated keys and text

• TRIAC dimmer

• FET dimmer

• Relay actuator

• Master contactor application

• 12VDC power supply

• Low-voltage adapter for load center applications

• 2.4Ghz 802.15.4 wireless RF network communications

• S5bus wired network communications

• Digital input for door switch contact / integration with the INNCOM energy management system (EMS)

• Software programmable for any CBL feature

Application

EVORA was developed to extend INNCOM switch capabilities beyond those offered in the well-established S-

Series (S217 and S5XX) product families and the innovative MODEVA series. The EVORA series uses a modular,

cross functional hardware platform that allows each of the three main products (multifunctional switch,

nightlight, and doorbell ) to share features in both hardware and software that were previously available only as

uniquely designed sub-assemblies in the legacy S-Series products.

EVORA has at its core the same Load Assembly (WBI) architecture used by INNCOM’s MODEVA line. The Load

Assembly is available in six configurations—500W relay, 500W TRIAC dimmer, 350W FET dimmer, 30A master

contactor, 200mA power supply, and a low-voltage adapter (LVA)—that provide the mechanical platform and load

bearing capability for the EVORA system. The EVORA series differs from MODEVA in several ways. It uses a

Figure

EVORA Switch

Summary of content (10 pages)

PAGE 1
Confidential Copyright © 2012 INNCOM EVORA Series Datasheet Overview The EVORA family of switches offers an elegantly designed, easy to use, feature-rich user interface and control system providing a state-of-the-art guestroom automation experience. EVORA allows guest control of multiple lighting loads, temperature, drapes, and guest annunciation from multiple switch locations in the guestroom.
PAGE 2
EVORA Datasheet Page 2 of 10 standard dimension mounting bracket, for instance, allowing EVORAs to be ganged with other products (similar to the S-Series). EVORA products come factory assembled. Categories of Load Assembly Load Switching • TRIAC dimmer provides dimming control of resistive light loads such as incandescent, halogen, and TRIAC dimmable LEDs. The TRIAC dimmer can dim 100–120VAC loads up to 500W.
PAGE 3
EVORA Datasheet Page 3 of 10 4. Wire the Load Assembly as described in the Wiring Diagrams. Depending on gang assembly using the appropriate 10, 12, 14, 16, or 18 AWG wire nut. 5. Push all wires back into the wall box and fasten the control to the wall box using the supplied mounting screws. Be sure not to pinch or disconnect any of the wires. 6. Ensure the intended load(s) are connected to the circuit. 7. Replace the fuses in the fuse panel or move the breaker to ON before continuing.
PAGE 4
EVORA Datasheet Page 4 of 10 The EVORA and Load Assembly is supplied with two 1¼" 6/32 screws, two 3-pin S5bus harnesses and a two-pin pig-tail harness for the digital input.
PAGE 5
EVORA Datasheet Page 5 of 10 Figure 6 EVORA WBI Triple Wiring In double and triple configurations, refer to the wiring diagram for S5bus and digital input connections. Daisy chaining is required only if all EVORA units need to be on the same S5bus or a parallel power design is needed for higher load capacity (See Class 2 Output table below). Master Contactor Use for master contactor applications up to 30A. This assembly requires an external +12VDC source.
PAGE 6
EVORA Datasheet Page 6 of 10 WBI Power Supply Use for applications where EVORA must be line powered but does not require load dimming or switching. 200mA DC output. Figure 8 EVORA WBI Power Supply Wiring Low Voltage Adapter The EVORA can be equipped with the Low Voltage Adapter (LVA). This allows the EVORA to act as a remote, +12VDC powered device only.
PAGE 7
EVORA Datasheet Page 7 of 10 Technical Specifications User Interface Maximum # of inputs Alternate User Interface Communications Input Power Audio Micro controller Dimensions Tactile input 1-7 tactile keys Keypad—traditional mechanical switches Wired S5bus 2.4Ghz RF 12VDC, up to 250mA* 8 ohm, 0.
PAGE 8
EVORA Datasheet Page 8 of 10 Load Specifications Single Gang Installation The following table provides the load ratings at absolute maximum based on the load type in a single gang wall box.
PAGE 9
EVORA Datasheet Page 9 of 10 Operating Conditions Table Header Table Header Storage Operating 68-176 degrees F; 20–80 degrees C, non-condensing 50-122 degrees F; 10–50 degrees C, non-condensing Ordering Information The highly configurable EVORA product line features many options for function (programmable control, doorbell, nightlight), appearance, user interface, and Load Assembly. The Ordering Guide below is for the EVORA final assembly.
PAGE 10
EVORA Datasheet Page 10 of 10 Logic OPN Description 1–5 button logic board w/radio 2 button nightlight logic board w/ radio 2 button logic board w/radio MB NL 202-111 202-113 DB 202-114 Button OPN Description 1, 2, 3, 3b, 4, 4b, 5 button (Nightlight and Doorbell are 2 button only) - Part Number - Housing Color OPN Description White Black Light Almond Eagle Almond Part Number Part Number WH BK LA EA Document Revision History Revision 0.1 0.2 0.3 1.0 1.01 2.