User's Manual

ManualsBrandsINNCOM International ManualsElectronicsPC-502.2

INNCOMȱPCȬ502.2ȱDatasheetȱ

Overviewȱ

The INNCOM PC-502.2 wall mounted module can be used to expand the

range of a Layer-2 RF network or provide the protocol gateway from

INNCOM S5-bus to Layer-2 RF protocol.

In the Layer-2.2 802.15.4 Zigbee 2006 mesh network, the PC-502.2 is

designed to patch areas within the network where signal strength is lost

due to distance limitations or interference. It also serves to create multiple

pathways, increasing the redundancy of the mesh communications to

ensure maximum network reliability.

Featuresȱ

x Small wall mountable form factor

x 2.4Ghz IEEE 802.15.4 compliant RF transceiver (CC2430 radio

core)

x Medium and long range variants available

x Industrial temperature ratings 0-65 degrees C

x FCC Part 15b listed

Specificationȱ

Parameterȱ PCȬ502.2ȱ

RF Data Rate 250kbps

Antenna Type SMT

Indoor Range 100ft

Outdoor/ RF line-of-sight range 1000ft+

Transmit Power 10mW (+18dBm)

Receive Sensitivity -94.6dBm

Frequency Band 2.405-2.475GHz

Encryption AES-128

Protocol 802.15.4

Frequency Channels 15

Input Voltage 12VDC

Current Consumption 100mA (Peak)

Operating Ambient Temperature 40 ° C

LED /Switch Reset indication, blinks when unit is connected to an RF

network. Rapid blink during binding association.

Figure 1 PC-502.2

10dBm

0-40℃,0-95%RH

Summary of content (5 pages)

PAGE 1
INNCOMȱPCȬ502.2ȱDatasheetȱ Overviewȱ The INNCOM PC-502.2 wall mounted module can be used to expand the range of a Layer-2 RF network or provide the protocol gateway from INNCOM S5-bus to Layer-2 RF protocol. In the Layer-2.2 802.15.4 Zigbee 2006 mesh network, the PC-502.2 is designed to patch areas within the network where signal strength is lost due to distance limitations or interference.
PAGE 2
INNCOM PC-502.2 Datasheet Page |2 Ranges are determined by performing an RF link quality test using e528.3G thermostats as the transmitter and the PC-502.2 as the receiver. The maximum distance threshold is based on a 95% overall link quality. Outdoor ranges were conducted in a low noise, free air environment. Indoor ranges are for reference. Indoor ranges are affected by the ambient environmental noise floor and building construction materials.
PAGE 3
INNCOM PC-502.2 Datasheet Page |3 Commissioningȱ The PC-502.2 must be bound to the controlling device (e.g., the E529.RF in Figure 2 above) to receive configuration information. On the E529.RF in service mode x Open the run menu and press Off/Auto x Set the value to 3 and press Display x When Display is pressed, the e529.RF sends Layer-2 configurations to the PC-502.2.
PAGE 4
INNCOM PC-502.2 Datasheet 3-S5-bus Page |4 Multi-drop In/Out - H6ȱ(SystemȬ5)ȱ Pinȱ 1-GND 2-12VDC 3-S5-bus 4–InOut1 5-InOut2 Functionȱ Common Input voltage Multi-drop TTL TTL Typeȱ In In/Out In/Out In/Out Minȱ 11.75 Maxȱ 12.25 - 3-pin to 3-pin harness for 12VDC and S5bus connection OrderingȱInformationȱ PartȱNumberȱ 01-5010.2 OPNȱ PC-502.2 Descriptionȱ PC-502 with 02-9894 20db Radio DocumentȱRevisionȱHistoryȱ Revisionȱ 0.1 0.2 1.
PAGE 5
Warning Any Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.