Envoi HL Transmitter User Guide Appendix English ( 2 – 5 ) English ( 6 )
User Guide (English) Introduction Refer to the Operation chapter to start using Envoi HL Transmitter. Box Contents Envoi HL Transmitter User Guide 2 AA Batteries Safety & Warranty Manual Lavalier Mic Headset Mic Support For the latest information about this product requirements, compatibility information, etc.) and registration, visit denonpro.com.
Features 1 2 3 4 Front Panel 1. IR Transmitter: Hold this up to a receiver to pair. 2. Battery Compartment: Install 2 AA batteries inside by pulling both sides of the compartment 1 (with the arrows pointing to you) to open. Make sure the polarities of the batteries (+ and –) are installed correct. 1 IR 2 Top Panel 1. Microphone Input: When using the included lavalier or headset microphones, input the connector into the input and screw in the connector clockwise to secure the cable.
Operation Wireless Mic Setup To use a wireless mic, follow these setup steps: 1. Ensure 2 new AA alkaline batteries are installed in the Envoi HL Transmitter. 2. Pair the mic to a receiver. Both the Denon Professional Envoi and the Marantz Professional Voice Rover can be used as a receiver. a. Turn on the Envoi HL Transmitter and the receiver. b. Select the UHF channel on the receiver that you want to use with the best reception. c.
Troubleshooting If you encounter a problem, try doing these things first: • Make sure all cables and other devices are properly and securely connected. • Make sure you are using the Envoi HL Transmitter as described in this User Guide. • If you believe Envoi HL Transmitter is not working properly, check the following table for your problem and solution. Problem: Solution: Please see: Power does not turn on. Make sure a fresh pair of AA batteries are Operation> installed in the Envoi HL Transmitter.
Appendix (English) Technical Specifications Specifications are subject to change without notice. Wireless reception and range are affected by walls, obstructions, and movement. For optimal performance, place the product in the center of the room so it is unobstructed by walls, furniture, etc. Power Power Adapter: 5V DC, 3 A, center-positive Input Voltage: 100 – 240V AC, 50/60 Hz Frequency Range 863 – 865 MHz (EU/UK), 584 .4– 606.
This device complies with part 15 of the FCC Rules. Operation is subject to the condition that this device does not cause harmful interference (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.
denonpro.com Manual Version 1.