使用手册 6TH FLOOR, BUILDING 8, TONGFUYU INDUSTRY CITY, XILI, NAN SHAN, SHEN ZHEN, CHINA 518055 1 Tel: 0755-25722469 Fax:0755-25727563
1. Introduction INMOTION V3 is a self-balancing unicycle type SCV (Sensor Controlled Vehicle). It is stylish, fun and practical, integrated with a unique hidden draw-bar, auto-switch lights, a touch screen, a slide-to-open charging port and built-in high quality Bluetooth speakers. INMOTION V3 is easy to learn, safe to ride, practical to commute.
装饰板 decorating plate 脚踝护垫 Ankle Pad 动力电机 Motor 触摸开关 Touch Screen 小腿护垫 Calf Pad 蓝牙音箱 Bluetooth Speaker 脚踏板 Footboard 停车脚垫 Stop-stand Rubber 橡胶轮胎 Tire 2. Packaging INMOTION V3 package includes the following parts when leaves the factory. Please check carefully before using the product, any missing or visible damaged parts should be reported to your dealer immediately. 1 INMOTOIN V3 2 User’s manual 3 Charger Adaptor 4 Warranty card, Product Certificate 3.
z Wear a helmet, elbow and knee protection when riding the INMOTION V3. z Do not ride on steep slopes that are over 20 degrees. z Do not accelerate and decelerate hardly or abruptly on the slopes. z Pay attention to obstacles and be careful of skid when riding the INMOTION V3. z Do not ride on grass. z Do not ride on pebble roads or any other unsmooth surfaces. z Do not drive into water that is over 170 mm. 3.
4.2 Display Panel Figure 2.2 Display Panel Light Power Slide Direction 5. How to Use 5.1 Power On Touch the Power icon and gently slide towards the arrow direction (Figure 3.1). 5.2 Hibernation and Shutdown z Touch the Power icon and slide towards the arrow direction to hibernate the system. In between you may also hear a sound prompt. In hibernation mode, if the system is left unoperated for 2 hours, the system will automatically shut down.
5.3 Light Power on the system and slide your finger from right end to left end (towards the opposite arrow direction), the lights on both sides will be illuminated in white. Roll the INMOTION V3 in a direction, the front light will illuminate in white with full brightness and the back light will turn into red. The lights will automatically change in white and red according to the riding direction of INMOTION V3. 5.
powered on. Turn on Bluetooth on your cellphone, search and pair the Bluetooth signal of the INMOTION V3 (Figure 3.4). If the signals are successfully paired, you may play music through the INMOTION V3’s Hi-Fi loud speakers. 5.5 Assist Mode Press down the draw-bar button, pull up the handle till the highest and then release the button. Now you can trolley the INMOTION V3 like a suitcase. Figure 3.5 5.6 Power Indicator There are two battery indicators along the two sides of the touch panel.
will be illuminated. 5.7 Charge INMOTION V3 Slide to open the charging port to charge. If the INMOTION V3 is charging, the charging indicator on the Charger Adapter illuminates in red and the Battery Indicator Bars are rolling up and down. If the INMOTION V3 is fully charged, the charging indicator is in blue. Figure 3.6 5.8 Voice Prompt The system’s default prompt language is Chinese or English, you can change to other languages IF available through INMOTION APP.
5.9 Reset When unknown errors or abnormal situations occurred, you can press the Reset button to turn off the INMOTION V3 completely. The Reset button can be seen after sliding the charging port cover to the right and it is on the left side of the charging port. 5.10 Water and Dust Proof V3 is rated IP55 for water and dust proof. It can maximally pass through 170 mm deep water. 5.11 Over Speed Protection When the speed is over 18 km/h (11 mph), the footboard will lean back at about 3~4°.
low under hibernation or power off mode. Low battery will make INMOTION V3 to lean back to warn the rider, there will also be a voice prompt. The system will protect the battery from over discharging when it is powered off. You may wake the V3 by charging the battery, if the INMOTION V3 is still not awaken please contact your dealer for a diagnosis. 5.14 Smart Phone Application The Application for INMOTION V3 works via Bluetooth 3.0 to connect the vehicle, it is suitable for Android 4.
Please inflate tires in time to make sure the pressure of the two tires are the same. The default tire pressure is 3.5 Bar. 6.3 Change Tire If you need to change the tires, please contact an authorized INMOTION service center or your dealer. 6.4 Adjust Footboard Please use a M8 screwdriver to adjust the tightness of the footboards if needed. 6.5 Cleaning Please gently clean the INMOTION V3 cases with a piece of soft cloth with clear water or soap water. 6.
Appendix: parameters No. Item Value Note 1 Max. Speed 18 km/h (11 mph) This speed is tested with a 75 kg (165 lbs) payload. 2 Distance per charge 20~25km (12.5~15.5 The distance per charge is obtained miles) under the following test conditions: room temperature, 75 kg (165 lbs) payload and smooth terrain. 3 Climbing Angle 18° 4 Recommended best -10~40℃ operating temperature (14~104°F) 5 Max load 120 kg (265 lbs) 6 Charge time 1.
pushing off the ground. z Make sure that the INMOTION V3 would always be right in the middle of your legs and not go other directions. z Keep your body straight up and get relaxed, look forward and naturally get on another foot. When you lift another foot off the ground, your body weight is slightly shifting to the foot standing on the footboard. z It is better that someone can hold your arms to help you get balanced or you can learn to get on the vehicle by pushing your hands against a wall.
INMOTION Customer Care Center: 4000-1000-12 +86 (0)755-8209-1768 6TH FLOOR, BUILDING 8, TONGFUYU INDUSTRY CITY, XILI, NAN SHAN, SEN ZHEN, CHINA 518055 Tel: 0755-25722469 Fax: 0755-25727563 13
8.
9. Maintenance record Description of Authorized Remark Solution Date Signature malfunction Limitation for warranty The obligations and responsibilities of warranty of INMOTION for the products and accessories, are restricted to free maintenance of reparation and replacement of defective parts within warranty periods. INMOTION assumes no responsibility (also does not authorize any third party to assume the responsibility) for service beyond this scope.
FCC Caution: Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate this equipment. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.