Falcon Quick Start Guide V1.2 2021.
Contents Introduction 1 Product Contents Falcon diagram Product Usage Charging Installation of Action Camera Power Button Shutter Button 1 2 3 3 3 4 4 5 5 7 Function Operation Mode Function Four-directional Joystick Operation Mode Switch Button Trigger Button Operation Manual Lock Indicator Light Status 7 8 9 9 Disclaimer 10 Product Parameter 11
Falcon Quick Start Guide Introduction Falcon is a hand-held stabilizer specially designed for cameras, which supports most of Action Cameras on the existing market, Through the three-axis motion compensation to stabilize the Action Camera to get a stable effect.
Falcon Quick Start Guide Falcon diagram Roll Axis Roll Axis Balance Adjustment Pan Axis PF HL FPV Shoot Button REC Button Time-lapse Button FL Status Indicator light Joystick ON/OFF Button/ Power Display Button Mode Button Handle Tilt Axis Camera Roll Axis Balance Adjustment Camera Mounting Plate Screw Charging Interface Trigger Button Camera not included.
Falcon Quick Start Guide Product Usage Charging Use TYPE-C cable to charge. The status indicator is red when charging while the green light is always on when fully charge. PF HL FPV FL Note : Make sure to fully charge the stabilizer when use for the first time. Please charge the stabilizer immediately if the power is too low and the red-light flashes slowly. Turn off the power if not in use.
Falcon Quick Start Guide Power Button ① Under the condition of power on or off, Long press two seconds the power button to turn on or turn off the gimbal. ② Under the condition of power on or off, single press the power button to display the power of stabilizer. ③ In the boot state, double press the power button into standby mode, and then single press any button to restore the working state of the stabilizer. ④ In the boot state, continuously and quickly press eight times to clear the remote-control pairing.
Falcon Quick Start Guide Function Operation Mode Function ① Following Mode Following Rotation Following Rotation PF HL FPV FL PF HL FPV FL Pan and Tilt Following Mode Single press the Mode Button again Pan Following Mode Single press Mode Button Following Rotation PF HL FPV FL Full Following Mode Single press the Mode Button again ② Lock Mode Locked direction PF HL FPV FL Pan and Tilt Locked Mode Long press trigger button The red circle indicates that the motor follows the movement of the h
Falcon Quick Start Guide ③ Vertical shooting Mode and Flashlight Mode Double click to enter vertical shooting mode, double click again to ener Flashlight Mode. Single click to exit to HL mode. Vertical Shooting Mode Mode Description Pan Following Mode (default) Tilt axis and roll axis keep the same direction, and the lens rotates with the direction of the handle. Pan and Tilt Following Mode Roll axis keep the same direction, and the lens rotates with the direction of the handle.
Falcon Quick Start Guide Trigger Button Operation Status Indicator Light Up PF HL FPV FL PF HL FPV FL Four-directional Joystick Right Left Mode Button ON/OFF Button/ Power Display Button Down Joystick Operation Description Push upwards /downwards Tilt axis rotates up or down Push left/right Pan axis rotates left or right. Mode Switch Button 1、Illustration ① Single click to switch PF-HL-FPV mode. ② Double click to enter vertical shooting mode, double click again to ener Flashlight Mode.
Falcon Quick Start Guide PF HL FPV FL PF HL FPV FL Vertical Mode (the indicator light flashes) Mode PF HL FPV FL Flashlight Mode Lock Mode Trigger Button Operation Trigger Button Trigger Button Operation Press and hold Into GL mode (release will back to previous mode) Double press Reset (Tilt axis and roll axis) Three-times press 8 Description 2021 INKEE Falcon All Rights Reserved Pan axis rotate 180. Tilt axis and roll axis back to original position.
Falcon Quick Start Guide Manual Lock Grasp the camera and pull it to the specified angle in the tilt direction, stay for half a second and then lock the current angle. Indicator Light Status Indicator Light Status Description Power off and standby mode shows the current power from left: 0-25%, 25-50%, 50-75% and 75-100%.
Falcon Quick Start Guide Disclaimer Warning The contents mentioned in this article are related to your safety, legal rights, and responsibilities. Please read them carefully and set up and use this product correctly according to the instructions. If you do not follow the instructions and warnings in this article, it may cause harm to you and the people around you and damage the product or the products around you. Any illegal use by any user is prohibited.
Falcon Quick Start Guide Product Parameter 104 92 207 236 111 37 Product Dimension: 236mm×111mm×37mm (Storage status) 104mm×207mm×92mm (Working condition ) Weight: 300g(battery included) Max.
Falcon Quick Start Guide Shenzhen Yingzhiqi Technology Co., Ltd Address: 18A, Ruijun Business Building, No.108,Central Road, Xinqiao Street, Bao’an District, Shenzhen, Guangdong Province Tel:+86 40096 80096 Website:www.in-kee.com Latest version of the User Manual is available at Official Website: http://www.in-kee.com/Falcon This manual is subject to update without prior notice. If you have any questions or suggestions about the manual, please contact us at the following email address: info@in-kee.