5_4 Camera (optional) Camera The Lane/7000 can be equiped with a module integrating a 5 megapixels autofocus camera. Reference of the module : MODU/7005 WiFi/BT Note: The Lane/7000 can be equiped with a module without camera.
6_Maintenance CAUTION Before making any operations of maintenance in the terminal, make sure that the power supply is disconnected. 6_1 Cleaning of the terminal First of all, unplug all the wires from the terminal. Good rules for proper cleaning of the terminal are : Do not clean the electrical connections. Do not use in any case, solvents, detergents or abrasive products : those materials might damage the plastic or electrical contacts. Avoid exposing the terminal to the direct rays of the sun.
6_3 Troubleshooting Device is not working Make sure that the Lane/7000 connector is fully inserted into the back of the device. Restart the device. If you have another working Lane/7000 device, swap the devices to determine if the problem is with the device, cable, POS, or power supply. If the Lane/7000 device is directly connected to a host, reset the host by turning it off and back on again.
WARNING Changes or modifications to this device not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. 7_Norms & Marking 7_1 Information to users in the United States and Canada Federal Communication Commission Interference Statement 47 CFR Section 15.105(b) This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
Under Industry Canada regulations, this radio transmitter may only operate using an antenna of a type and maximum (or lesser) gain approved for the transmitter by Industry Canada. To reduce potential radio interference to other users, the antenna type and its gain should be so chosen that the equivalent isotropically radiated power (e.i.r.p.) is not more than that necessary for successful communication.
7_2 No unauthorized modifications Federal Communication Commission Interference Statement 47 CFR Section 15.21. Consult the dealer or an experienced radio/TV technician for help. CAUTION This equipment may not be modified, altered, or changed in any way without signed written permission from Ingenico. Unauthorized modification may void the equipment authorization from the FCC and will void the Ingenico warranty.
Ingenico ensures that efficient collection and recycling schemes are set-up for WEEE and batteries according to the local regulation of your country. Please contact your resellers for more detailed information about the compliance solution in place for disposing of your old product and used batteries. Packaging waste must also be collected separately to assure a proper disposal and recycling.
The C-Tick is an identification trademark registered to the Australian Communications Media Authority (ACMA). The C-Tick mark signifies that the labelled electronic device is compliant with applicable electromagnetic compatibility (EMC) requirements. Waste of Electrical and Electronic Equipment (WEEE) symbol indicates that when the end-user wishes to discard this product, it must be sent to separate collection facilities for recovery and recycling.
“This Document is Copyright © 2019 by INGENICO Group. INGENICO retains full copyright ownership, rights and protection in all material contained in this document. The recipient can receive this document on the condition that he will keep the document confidential and will not use its contents in any form or by any means, except as agreed beforehand, without the prior written permission of INGENICO.