Contactless Payment Expansion Module for the eN-Touch 1000 Installation Guide
Contactless Payment Expansion Module for the eN –Touch 1000 Installation Guide Part Number DIV350403, Revision A Released July 2005 Copyright 2005, Ingenico Corp. All rights reserved. No part of this publication may be copied, distributed, stored in a retrieval system, translated into any human or computer language, transmitted, in any form or by any means, without the prior written consent of Ingenico. Ingenico and Ingenico logo are registered trademarks of Ingenico Corp.
Table of Contents 1 Overview .............................................. 1 2 Installation Components ....................... 1 3 Installation Procedure .......................... 2 3.1 3.2 Preparing the Terminal for the Installation ................................ 2 Expansion Module Installation Steps......................................... 3 4 Testing the Installation ......................... 6 5 Product Certification ............................
includes the following: Card Reader Unit, Cable, Tyco/Loki Foot, Thor Foot, Wedge, Double sided tape and Plastic bag with one mounting screw and two self-adhesive rubber bumps Only the Expansion Module Foot for your terminal model is required! 3 Installation Procedure - Only upgrade terminals that are in working order. - This procedure requires a Philips screw driver. ! 3.1 Preparing the Terminal for the Installation 1. Disconnect the terminal from power. 2.
3.2 Expansion Module Installation Steps Step 1: Assemble the cable assembly into the Foot required for your installation as shown in Figure 3. Ensure that the cable is positioned in the cable retention feature of the Foot. Note that the cable is routed differently according to the model you have: for the Tyco/Loki model place the Minidin 9 cable under the RJ cable.
Mounting screw Figure 5: Foot/Reader Unit assembly Step 4A-Tyco/Loki model only: Attach the Foot/Reader Unit assembly to the terminal by connecting first the Minidin 9 connector to the terminal jack, than placing the two bottom mounting tabs of the Foot into the terminal recesses and finally by squeezing in the top mounting tab of the Foot into matching locating hole of the terminal. Foot mounting screws are NOT required. See Figure 6.
Self-adhesive bumps here Screws here Figure 7: Attach the Thor Expansion Module to the terminal Step 5: Apply the two self-adhesive rubber bumps to the Module Foot as shown in Figure 7. The orientation angle of the Card Reader antenna can be adjusted through 3 discrete positions. The optional Antenna Positioning Wedge included in the kit can be used to fix the antenna semi-permanently in Position 1 or Position 2. Position 3 does not require the wedge.
Step 7: Install the Wedge as follows: • Fully insert the Wedge for the desired position in the recess at the back of the Antenna as shown in Figure 9. • Ensure the Wedge is located and attached properly to the top of the Reader surface through the use of the included double sided tape. • Check the Wedge is locked in the Antenna recess by pushing the Antenna against the Wedge as shown by the arrows. If movement, reposition. Figure 9. Figure 10 shows the results of the Wedge installation.
Figure 17: Reading a contact-less smartcard • Place the contact-less smartcard near the Card Reader. • Confirm the successful reading of the contact-less smartcard. 5 Product Certification ! This device complies with Part 15 of FCC Rules.
! Changes or modifications not expressly approved by manufacturer could void the user’s authority to operate the equipment 8 Contactless Payment Expansion Module eN –Touch 1000 Installation Guide