BR-3503 User Manual (North America) Rev.
! Important Safety Instructions 1. Carefully read all of the instructions provided and save them for later use. Heed all warnings and instructions marked on the BR-3503. 2. Do not place the BR-3503 on an unstable stand or surface as it may fall resulting in serious damage. 3. The BR-3503 must be operated from 115 Volts AC 60Hz. Operating voltage is factory set. 4. The BR-3503 power cord is equipped with a three-prong grounding plug that will only fit into a grounding type power outlet.
1. General The BR-3503 radar can be used to measure the radial velocity of any moving object located in the radar beam coverage. The output of the radar is an analog signal with a frequency and amplitude proportional to the radial velocity and distance of the moving object. 2. Microwave Safety Warning ! Based on limits specified by the Federal Communication Commission (FCC) on Radio Frequency (RF) emissions in a general population environment, continued exposure to radiation should be avoided within 1.
5. Operation The BR-3503 is powered on 115Vac 60Hz. The connection to the power line outlet is done using a permanently attached power cord. It is interfaced to a Doppler processor unit using a single four-wire cable equipped with military connectors. This cable is used to carry the radar Doppler signal to the processing unit and the antenna transmission control signals. You should connect your radar cable from this connector to the appropriate radar input on your processing unit.
LIMITED WARRANTY. Infinition Inc. products are warranted against defects in materials and workmanship for a limited period of time from the date Infinition Inc. ships the products to the customer as follows: interface hardware (one (1) year); cables, cable reels, radar antennas and acoustic sensors (ninety (90) days); and software medium (ninety (90) days). All software products sold by Infinition Inc. are licensed to the customer under the terms of the product software license agreement.
Infinition Inc. March 23, 2010 Safety Warning Justification BR-3503 Doppler Radar Safety warning contained in the BR-3503 User Manual: “Based on limits specified by the Federal Communication Commission (FCC) on Radio Frequency (RF) emissions in a general population environment, continued exposure to radiation should be avoided within 0.5 meter in front of the radar. Radiation levels outside this region fall within regulations of 1 mW/cm2 and are not considered safety hazards.