BR-29015 User Manual (North America) Rev.
Important Safety Instructions ! Carefully read all of the instructions provided and save them for later use. Read all warnings and instructions marked on the BR-29015. ! Do not place the BR-29015on an unstable stand or surface as it may fall resulting in serious damage. ! The radar antenna should be handled with great care at all time to avoid damaging the antenna radome. Radome damage can result in serious performance degradation. ! The BR-29015 must be operated from a 115Vac 60Hz power source.
! Do NOT plug in, turn on or attempt to operate an obviously damaged unit. ! No operator serviceable parts inside the BR-29015 radar unit. Please refer servicing to service qualified personnel. Infinition Inc. Rev.
1. General The BR-29015 radar can be used to measure the radial velocity of any moving object located in the radar beam coverage. The output of the radar is an analog signal with a frequency and amplitude proportional to the radial velocity and distance of the moving object. 2. Microwave Safety Warning ! Based on limits specified by the Federal Communication Commission (FCC) on Radio Frequency (RF) emissions in a general population environment, continued exposure to radiation should be avoided within 10.
processing unit and the antenna transmission control. You should connect your radar cable from this connector to the appropriate radar input on your processing unit. The radar head has an override transmitter control switch that can be used to activate the transmitter locally at the antenna. In addition, the radar has a transmitter power control switch that can be used to select between low or high output power levels. At the low setting, the transmitter output power is 1.
7. Power Connector Specification Connector type: Amphenol T3110-000 Pin 1 2 3 4 Description AC Neutral 115Vac, 1.0A, 60Hz n/c Protective ground 8. Antenna Connector Specification Connector type: ITT CANNON MS3124E16-8P Pin A B C D E F G H Description Not Connected Not Connected Not Connected Remote Make for Antenna Transmitter Control (+ 5 Vdc Output, 1.5kOhm current limiting resistor) Make return Doppler Signal + (5 Vpp max.) Doppler Signal - (5 Vpp max.
10. Antenna Optional I/O Connector Specification Connector type: ITT CANNON MS3124E10-6SW Pin A B C D E F Description Not Connected Not Connected Not Connected Not Connected Not Connected Not Connected Infinition Inc. Rev.
LIMITED WARRANTY. Infinition Inc. products are warranted against defects in materials and workmanship for a limited period of time from the date Infinition Inc. ships the products to the customer as follows: interface hardware (one (1) year); cables, cable reels, radar antennas and acoustic sensors (ninety (90) days); and software medium (ninety (90) days). All software products sold by Infinition Inc. are licensed to the customer under the terms of the product software license agreement.
